X502-622.08MHZ [CONNOR-WINFIELD]
LVDS Output Clock Oscillator, 622.08MHz Nom;
| 型号： | X502-622.08MHZ |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | LVDS Output Clock Oscillator, 622.08MHz Nom 机械 振荡器 |
| 文件： | 总2页 (文件大小：178K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
PRELIMINARY
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
3.3V SURFACE MOUNT 5.0 x 7.5m m
LVDS CLOCK OSCILLATOR
X502
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
Storage Temperature
-40
-
-
85
DESCRIPTION
Supply Voltage
(Vcc)
-0.5
7.0
Vdc
The Connor-Winfield X502 is a
3.3V Crystal Controlled Oscillator
(XO) with LVDS Differential
outputs. The X502 is designed for
use with PLL systems requiring
tight frequency stability vs.
temperature. The use of 4x
multiplication is utilized in this
oscillator design.
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
Center Frequency
(Fo)
-
622.08
-
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-20
-
-
20
ppm
1
0
70
°C
(Vcc)
(Icc)
3.135
3.3
-
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
-
100
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 80MHz)
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
-
10
2
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-75
-95
-110
-125
-120
-
-
-
-
INPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
NOTE
-
-
Enable Input Voltage (Low)
Disable Input Voltage (High)
(Vil)
-
0.3Vcc
-
2
2
(Vih)
0.7Vcc
Vdc
FEATURES
LVDS OUTPUT CHARACTERISTICS
PARAMETER
TABLE 4.0
NOTE
3
3.3V OPERATION
MINIMUM NOMINAL MAXIMUM
UNITS
Ohms
mV
LOAD
-
250
45
-
-
-
100
450
55
LOW JITTER <2pS RMS
Output Differential Voltage
Duty Cycle at 50% Level
Rise / Fall Time
(Vod)
50
0.6
%
TOTALFREQUENCY TOLERANCE:
±20ppm
1.0
nS
TEMPERATURE RANGE: 0 to 70°C
DIFFERENTIAL LVDS OUTPUTS
SURFACE MOUNT PACKAGE
TAPEAND REEL PACKAGING
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Hermetically sealed ceramic package with grounded met al cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
SMD product suitable for Convection Reflow soldering. Peak temperature
260°C. Maximum time above 220°C, 60 seconds.
Notes
1.0
Inclusive of calibration @ 25°C, frequency stability vs. temperature, control voltage (Vc) = 1.65 Vdc and aging for ten
years.
2.0
3.0
When oscillator is disabled both output are in a high impedance state (Tri-State)
Vod measured with 100 ohm resistor between the true output and the complementary output.
ORDERING INFORMATION
X502
- 622.08MHz
LVDS
CLOCK
SERIES
CENTER
FREQUENCY
Specifications subject to change without notice.
2/26/04
DS017
1
2
00
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
PRELIMINARY
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
Pin Function
N/C
1
2
3
4
5
6
Enable / Disable
Ground (Case)
Output Q
Comp Output Q
Vcc
Dimensional Tolerance:
±.005 (.127mm)
Timing Chart
Q
Vod
100
ohm
2
Q
N/C
E/D
Specifications subject to change without notice.
2/26/04
DS017
00
2
2
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
相关型号：
©2020 ICPDF网 联系我们和版权申明