PE2244BV-70.0M-XXX [ETC]

10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad; 10引脚无引线表面贴装时钟振荡器,看到PE1145B的6Pad
PE2244BV-70.0M-XXX
型号: PE2244BV-70.0M-XXX
厂家: ETC    ETC
描述:

10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad
10引脚无引线表面贴装时钟振荡器,看到PE1145B的6Pad

振荡器 时钟
文件: 总1页 (文件大小:42K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
Pl tronics, Inc.  
.
19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA  
Manufacturer of High Quality Frequency Control Products  
PE2245B PECL Series  
10 Pad Leadless Surface Mount Clock Oscillator, see PE1145B for 6 Pad  
Differential PECL Output with or without Enable/ Disable Function  
10.00 MHz 170.00 MHz  
See PE1145T for higher frequencies  
All Connor-Winfield EE94-5XX Pinouts Available  
Standard Specifications  
Overall Frequency Stability  
± 50 PPM, ± 25 PPM, ± 20 PPM over Operating Temperature Range  
-
°
Operating Temperature Range 0 to +80 C is standard, but can be extended to 40 to +85°C for certain frequencies  
Supply Voltage (Vcc)  
Supply Current (Icc)  
Jitter  
3.3 volts ± 10% standard, but 5.0 volts or 2.5 volts also available  
³
60 to 70 mA typical, 90 mA maximum for 70 MHz. For < 70 MHz, consult factory  
1 pS RMS maximum, from 12 kHz to 20 MHz from carrier for ³ 70 MHz. For < 70 MHz, consult factory  
Output must be terminated into 50 ohms to (Vcc - 2.0 V). See Test Circuit 5 and Note 1.  
Output enabled when E/D Pin is open or at CMOS Logic “1”;  
Output Load  
Enable/Disable Option (E/D)  
(as applicable)  
Output disabled when E/D Pin is at CMOS Logic “0”.  
Symmetry  
Tr & Tf  
Logic “1”  
45/55% to 55/45% at 50% of Vcc level standard, tighter symmetry available  
Output Waveform  
PECL with Differential Output  
(see Waveform 2)  
³
1.0 nS max (20 to 80%) for 70 MHz. For < 70 MHz, consult factory  
Vcc - 1.025 volts minimum  
Vcc - 1.620 volts maximum  
Logic “0”  
Note 1:  
In the typical PECL 100K logic output Voh is 2.35 volts and Vol is 1.60 volts at 3.3 Vcc. The center voltage of the PECL is therefore1.975 volts.  
If a 50 ohm resistor is placed between the output and Vcc – 2 volts (1.3 volts), the current through the resistor is (1.975 – 1.3) / 50 = 13.5 mA.  
±
The same load can be simulated by a resistor of 147 1% ohms to ground (1.975 / 0.0135 = 146.29 ohms). If additional load current is placed  
on the output, its load current must be subtracted from the 13.5 mA to calculate a new load resistor. Using similar calculations, use 274 ± 1%  
ohms to ground for 5.0V operation.  
Part Numbering Guide  
Portions of the part number that appear after the frequency may not be marked on part (C of C provided)  
PE22 45 B Y - 70.0M - XXX (Internal Code or blank)  
Model  
Packaging  
(Pinout Option)  
Frequency in MHz  
Tray or  
PE20 PE23  
PE21 PE24  
PE22  
24mm tape,  
16mm pitch  
Special Specifications (choose all that apply)  
°
E: Extended Operating Temperature Range (- 40 to +85 C)  
F: 47.5 /52.5% Symmetry at 50% of Vcc  
V: Supply Voltage of 3.3 volts ± 10%  
W: Supply Voltage of 2.5 volts ± 5%  
Y: Supply Voltage of 5.0 volts ± 10%  
Frequency Stability  
45 = ± 50 PPM  
44 = ± 25 PPM  
20 = ± 20 PPM  
Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.  
Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load  
Mechanical: inches (mm)  
not to scale  
Solder Pads  
Due to part size and factory abilities, part marking may vary from lot to lot and may contain our part number or an internal code.  
Q
Vcc  
*
10  
9
8
7
6
6
7
8
9
10  
PLE  
.05  
(1.3)  
N.C.  
N.C.  
N.C.  
N.C. N.C.  
2
1
5
4
3
1
2
3
4
5
GND  
*
.560 (14.23) MAX  
.217 (5.5)  
MAX  
July 2002  
.400 (10.16)  
For Best Performance,  
C-W  
Option '0'  
'1'  
'2'  
'3'  
'4'  
Pin PE20 PE21 PE22 PE23 PE24  
2
*
PE2245B Series Pinout Options  
Connor-Winfield EE94-5XX Equivalents  
Do NOT allow any traces other than ground  
under oscillators (Even in buried layers)  
N.C. N.C. E/D QN E/D  
6
N.C. QN N.C. N.C. QN  
(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com  
Pl tronics, Inc.  

相关型号:

SI9130DB

5- and 3.3-V Step-Down Synchronous Converters

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1-E3

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135_11

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9136_11

Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130CG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130LG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130_11

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137DB

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137LG

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9122E

500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification Drivers

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY