TRC-150S105DT [ETC]

Switch Mode LED Drivers;
TRC-150S105DT
型号: TRC-150S105DT
厂家: ETC    ETC
描述:

Switch Mode LED Drivers

文件: 总3页 (文件大小:721K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
TRC-150W Dimmable Series  
Switch Mode LED Drivers  
Constant Current  
Aluminum Housing  
Electrical Specifications  
Input Voltage Range:  
100 - 277 Nom. Vac (90 - 305 V Min/Max)  
Frequency:  
50/60 Hz Nom. (47-63 Hz Min/Max)  
>0.90 @ full load, 100V through 277V  
Power Factor:  
Inrush Current:  
Input Current:  
65 Amps maximum @ 230 Vac, cold start 25ºC  
1.8 A max 100Vac, 0.9 A max 220Vac  
Maximum Power:  
Line Regulation:  
Load Regulation:  
Leakage Current:  
Typical Efficiency  
Turn-on Delay:  
Ripple and Noise:  
Protection:  
150W  
± 1%  
± 3%  
0.75 mA 277 Vac 60Hz  
92.5%-93.5% at 220Vac  
0.5S typical 110Vac, 0.3S typical 220Vac  
13V at 350 mA  
Over-Voltage, Over-Temperature (110°C), Lightning,  
and Short Circuit Protection with Self Recovery  
Total Power: 150 Watts  
• Input Voltage: 100-277 Vac Nom.  
• UL Dry & Damp Location Rated  
• IP67  
Environmental Specifications  
Minimum Starting Temp: -35ºC  
• Ultra-high Efficiency  
• High Power Factor with Active Correction  
• UL8750  
Storage Temperature:  
Humidity:  
-40ºC to +85ºC  
5% to 100%  
Convection  
Class A  
Cooling:  
Sound Rating:  
MTBF:  
250,000 Hours (350 mA model) @ 110Vac input, 80%  
load and 25ºC ambient conditions per MIL-HDBK-217F  
230,000 Hours (1400 mA model) @ 110Vac input, 80%  
load and 25ºC ambient conditions per MIL-HDBK-217F  
Lifetime:  
Weight:  
350mA: 58,000 Hours @ 220Vac, 80% load, Tc=60ºC  
1400mA: 88,000 Hours @ 220Vac, 80% load, Tc=60ºC  
3.31 lbs. (1.5 kg)  
Dimming - Product Specifications  
New Surge Protection and HI-POT Testing  
Output Current Output Voltage Max. Output  
Typical  
Model Number  
(mA)*  
Range (Vdc)  
214~428  
166~333  
107~214  
107~142  
53~107  
Power (W) Efficiency  
TRC-150S035DT  
TRC-150S045DT  
TRC-150S070DT  
TRC-150S105DT  
TRC-150S140DT  
350  
150  
150  
150  
150  
150  
93.5%  
93.0%  
93.0%  
93.0%  
92.5%  
450  
700  
Metal Lock Sheet  
Nut  
1050  
1400  
* The output current is adjustable at factory from 50% to 100%.  
HI-POT Test  
Normal Application  
The new design of this LED driver provides 1.4KV surge protection. To properly  
HI-POT test this unit, the surge protection must be disconnected. The screw, nut, and  
metal lock sheet on the input side of the driver provide for this. To test, first remove  
the nut and lock sheet as shown. After testing, secure the nut and lock sheet to  
provide line-to-earth protection.  
This HI-POT test feature is available on product manufactured after August 15, 2015.  
E332160  
Note:  
LED drivers are designed and intended to operate LED loads only.  
Non-LED loading may be outside the specified design limits of our  
LED drivers, and therefore cannot be covered by any warranty.  
If you desire to use our LED drivers to operate non-LED loads  
please contact us to discuss compatibility.  
Specifications subject to change without notice.  
Rev 9-1-15  
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com  
TRC-150 Dimming Series  
SSL Solutions Faster Than The Speed Of Light®  
Pg 2 of 3  
AC INPUT (3*AWG #18)  
Dimming Control Wire  
(2*AWG #22)  
Black (ACL)  
White (ACN)  
Green (GND)  
Purple (1-10V)  
Gray (GND)  
DC OUTPUT  
(2*AWG #18)  
Red (V+)  
Blue (V-)  
Efficiency / Load  
Power Factor / Output Voltage  
THD / Output Voltage  
95%  
1.00  
0.95  
0.90  
0.85  
0.80  
0.75  
0.70  
0.65  
0.60  
20%  
16%  
12%  
8%  
90%  
85%  
80%  
120Vac  
220Vac  
277Vac  
120Vac  
220Vac  
277Vac  
75%  
120Vac  
220Vac  
277Vac  
4%  
70%  
60%  
0%  
70%  
80%  
90%  
100%  
60%  
70%  
80%  
90%  
100%  
60%  
70%  
80%  
90%  
100%  
Normalized Output Voltage  
Normalized Output Voltage  
Normalized Output Voltage  
Lifetime / Case Temperature (350mA)  
Lifetime / Case Temperature (1400mA)  
300  
250  
200  
150  
100  
50  
300  
250  
200  
150  
100  
50  
0
40  
0
50 Case Temperature (°C)  
Case Temperatur7e0(°C)  
60  
70  
80  
90  
30  
40  
50  
60  
80  
90  
Derating Curve  
Derating Curve  
100  
80  
60  
40  
20  
0
100  
80  
60  
40  
20  
0
100Vac  
277Vac  
-35  
-20  
-5  
10  
25  
40  
55  
70  
90  
120  
150  
180  
210  
240  
270  
300  
330  
Ambient Temperature (°C)  
Input Voltage (V)  
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com  
TRC-150 Dimming Series  
SSL Solutions Faster Than The Speed Of Light®  
Pg 3 of 3  
Dimming Control (on secondary side)  
Parameters  
Absolute maximum voltage on the 0~10V input pin  
Minimum  
-2 V  
Typical  
Maximum  
12 V  
Source current on 0~10V input pin  
0 µA  
1 mA  
The dimmer control is operated from an input signal of 1 – 10 Vdc. Recommended implementations are provided below.  
DC Input  
Output Current / Dimming Voltage  
100%  
80%  
0-10V Input (Purple)  
TRC-150xxxDT  
Rin  
0-10Vdc  
Gnd (Gray)  
V
60%  
40%  
20%  
0%  
0
2
4
6
8
10  
Vdim (V)  
Output Current / Rx  
External Resistor  
TRC-150xxxDT  
100%  
0-10V Input (Purple)  
80%  
60%  
Rx  
Gnd (Gray)  
40%  
20%  
0%  
0
20  
40  
60  
80 100 120 140 160 180 200  
Rx (k)  
Notes:  
1. Io is actual output current and Ir is rated current without dimming control.  
2. For the driver to operate properly, the load voltage must be maintained above the minimum voltage  
threshold (approx. 50% of the max. output voltage for any given model).  
3. If the output voltage is maintained above 50% of the maximum output voltage, the dimming control may  
be operated over the entire 1-10V range with output current varying from 10% to 100% of Ir.  
4. The dimming input signal may be less than 1V; however, no further dimming will occur between 0V and 1V.  
5. The internal resistor Rin is 20K, and Vcc is about 15V.  
6. Do not connect the GRAY of dimming to the output; otherwise, the LED driver can not work normally.  
Safety and EMC Compliance  
UL/CUL  
UL8750, UL1012, UL935, CSA-C22.2 No. 107.1-01  
C E  
EN 61347-1, EN61347-2-13  
EN 55015  
Conducted emission Test & Radiated emission Test  
Harmonic current emissions  
EN 61000-3-2  
EN 61000-3-3  
EN 61000-4-2  
EN 61000-4-3  
EN 61000-4-4  
EN 61000-4-5  
EN 61000-4-6  
EN 61000-4-8  
EN 61000-4-11  
EN 61547  
Voltage fluctuations & flicker  
Electrostatic Discharge (ESD): 8 kV air discharge, 4 kV contact discharge  
Radio-Frequency Electromagnetic Field Susceptibility Test-RS  
Electrical Fast Transient / Burst-EFT  
Surge Immunity Test: AC Power Line: line to line 2 kV, line to earth 4 kV  
Conducted Radio Frequency Disturbances Test-CS  
Power Frequency Magnetic Field Test  
Voltage Dips  
Electromagnetic Immunity Requirements Applies to Lighting Equipment  
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com  

相关型号:

TRC-150S105ST

Switch Mode LED Drivers
ETC

TRC-150S140DT

Switch Mode LED Drivers
ETC

TRC-150S140ST

Switch Mode LED Drivers
ETC

TRC-150S175ST

Switch Mode LED Drivers
ETC

TRC-150S210ST

Switch Mode LED Drivers
ETC

TRC-150S245ST

Switch Mode LED Drivers
ETC

TRC-150S280ST

Switch Mode LED Drivers
ETC

TRC-150S315ST

Switch Mode LED Drivers
ETC

TRC-150S350ST

Switch Mode LED Drivers
ETC

TRC-150S420ST

Switch Mode LED Drivers
ETC

TRC-150S490ST

Switch Mode LED Drivers
ETC

TRC-150S595ST

Switch Mode LED Drivers
ETC