FS319LF-C [FEELING]
SINGLE PHASE DC MOTOR DRIVE IC;型号: | FS319LF-C |
厂家: | Feeling Technology |
描述: | SINGLE PHASE DC MOTOR DRIVE IC |
文件: | 总13页 (文件大小:125K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
FS319
Technology
SINGLE PHASE DC MOTOR DRIVE IC
GENERAL DESCRIPTION
The FS319, a 1-chip composed of hall sensor and output coil drivers, applied to a
single-phase DC motor. The high sensitivity of Hall effect sensor is suitable for motors from
mini-type CPU coolers to blowers and DC fans. Typical operation current is 0.3A and
operating voltage range is wide.
Using few external components, FS319, a high performance integrated IC, is designed for a
single-phase DC motor circuit. The circuit diagram of the typical application example is as
below.
FEATURES
˙1 chip hall sensor/drivers
˙Wide operating voltage range: 3.0V~20V
˙Output sink current up to 0.3A
˙Output thermal–shutdown protect function
˙Package : TO92-4L
TO-92SP-4
TYPICAL APPLICATION CIRCUIT
VCC
FTC
S319
Rev0.3 Dec.29, 2005(LF)
P1/FS319
FS319
Technology
FUNCTIONAL BLOCK DIAGRAM
1
Regulator
2
Hall Sensor
Pre-driver
AMP
3
Thermal
shutdown
4
MARK VIEW
PIN DESCRIPTION
NAME NO. STATUS
DESCRIPTION
FTC
S319.
VCC
NO
1
2
P
IC Power Supply
Coil driver output
It is low state during the N
magnetic field.
O
Coil driver output
SO
3
4
O
P
It is low state during the S
magnetic field.
1
2
3
4
GND
IC Ground
Rev0.3 Dec.29, 2005(LF)
/FS319
P
2
FS319
Technology
ABSOLUTE MAXIMUM RATINGS
VCC Pin Voltage ------------------------------------------------------------------------------
Output Peak Sink Current (Io)
20V
Peak Current ------------------------------------------------------------------------
Hold Current -------------------------------------------------------------------------
Continuous Current ----------------------------------------------------------------
800mA
600mA
300mA
Power Dissipation
Ta=25 oC -----------------------------------------------------------------------------
Ta=70 oC -----------------------------------------------------------------------------
Silicon temperature up 150 oC thermal shutdown function enable.
Operating Temperature Range ----------------------------------------------------
Storage Temperature Range ------------------------------------------------------
600mW
450mW
-20 oC
-65 oC
~
85 oC
~
150 oC
+150 oC
+260 oC
Junction Temperature -----------------------------------------------------------------------
Lead Temperature (Soldering, 10 sec) --------------------------------------------------
oC
255 ± 5
10 ± 1 sec
150 ± 10o
C
90 ± 30 sec
oC
2 ~ 5 / sec
oC
2 ~ 5
/ sec
SECOND
Soldering Condition
Rev0.3 Dec.29, 2005(LF)
/FS319
P
3
FS319
Technology
DC ELECTRICAL CHARACTERISTICS
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
TYP MAX UNIT
Supply Voltage
VCC
3
—
20
25
V
-
Vcc= 20V
No use pin open (Fig1)
Quiescent Supply current
ICC
—
—
18
mA
Vce(sink) Vcc=14V, Ic = 200mA
Vce(drive) Vcc=14V, Ic = 200mA
0.55 0.80
Vcc
V
V
Output Saturation Voltage
Vcc-1.5V
—
Note:
Fig1 The IC output state is under N magnetic field.
AC ELECTRICAL CHARACTERISTICS
PARAMETER
Rise time
Fall time
SYMBOL
TEST CONDITIONS
MIN TYP MAX UNIT
RL=820
RL=820
Ω
Ω
CL=20pF (Fig 2)
CL=20pF (Fig 2)
(tr)
0.5
0.5
1.0
1.5
µ
µ
s
s
(tƒ )
Rev0.3 Dec.29, 2005(LF)
/FS319
P
4
FS319
Technology
MAGNETIC CHARACTERISTICS
Ta= -20 oC
~
85 oC
MAX
+65
FS319LF-A
PARAMETER
Bop
MIN
UNIT
G
Brp
-65
G
Bhys
130
G
Ta= -20 oC
~
85 oC
MAX
+80
FS319LF-B
PARAMETER
Bop
MIN
UNIT
G
Brp
-80
G
Bhys
160
G
Ta=-20 oC
~
85 oC
MAX
+120
FS319LF-C
PARAMETER
Bop
MIN
UNIT
G
Brp
-120
G
Bhys
240
G
FS319 HYSTERESIS CHARACTERISTICS
V
NO
V
SO
V
V
B
B
-65
-80
+65
+80
-65
-80
+65
+80
-120
+120
-120
+120
NO
PIN
SO
PIN
Rev0.3 Dec.29, 2005(LF)
/FS319
P
5
FS319
Technology
TEST CIRCUITS
FTC
S319
A
A
Vcc
V1
V
V
R2
R1
Fig 1. Test circuit
FTC
S319
R
Vcc
Fig 2. Test circuit
Rev0.3 Dec.29, 2005(LF)
P6/FS319
FS319
Technology
TYPICAL CHARACTERISTICS
45
40
-20
-25
35
30
25
-30
-35
-40
20
15
10
-45
-50
-55
0
12
Vcc-V
Figure 1
20
0
4
16
12
Vcc-V
20
4
16
8
8
Figure 2
95
90
45
40
85
8 0
75
35
30
25
70
65
60
20
15
10
0
12
20
4
16
8
-20
60
100
20
80
40
Vcc-V
TEMPERATURE
℃
Figure 3
Figure 4
85
80
-25
-30
75
70
65
-35
-40
-45
60
55
50
-50
-55
-60
-20
60
100
20
80
40
-20
60
100
20
80
40
TEMPERATURE
℃
TEMPERATURE
℃
Figure 5
Figure 6
Rev0.3 Dec.29, 2005(LF)
/FS319
P
7
FS319
Technology
FUNCTION DESCRIPTIONS
HALL SENSOR LOCATION
The Fig 4 is the hall sensor location, where marks the IC number. The best sensitivity,
which can be intensified as much as possible, depends on the vertical distance and position
between magnetic pole and the hall sensor (Fig 5). For the single-phase motor, this design
is very important.
X
UNIT
mm
Y
X
Y
1.75
1.35
mm
Fig 4 FS319 Hall Sensor Location
S
N
d
d1: hall sensor to case is 0.52mm
Fig 5 Magnetic Distribution and Z-axis position
Rev0.3 Dec.29, 2005(LF)
/FS319
P
8
FS319
Technology
H-BRIDGE TRANSISTOR OUTPUT
The Fig 6 is the circuit diagram of H-bridge transistors. The single-phase motor rotation
depends on a switching current of coil L1. When the magnetic pole is N pole, Q2, Q3, Q5 is
turn-off and Q1, Q4, Q6 is turn-on, L1 has a current from SO to NO. And when the magnetic
pole is S pole, Q1, Q4, Q6 is turn-off and Q2, Q3 is turn-on, L1 has a current from NO to
SO.
VCC
PNO
Q5
Q6
PSO
Q4
Q3
L1
NO
SO
DPSO
DPNO
Q1
Q2
GND
Fig 6 H-Bridge Transistors Output
Rev0.3 Dec.29, 2005(LF)
/FS319
P
9
FS319
Technology
APPLICATION NOTE
The Example of Typical Application Circuit
Fig 7 is the example of typical application circuit. The red, yellow, and black wires are the
input points of the motor system: red, the input of power supply; yellow, the output of FG;
black, the ground signal. RC is an external pull-up resistance for the use of measuring FG
signal. In view of the design, the value of RC could be decided by the transistor saturation
voltage (VON), sink current (IC), and off-level voltage (VC).
V
C −
V
ON
The formula is:
RC=
I
C
For example:
VC = +5V for TTL level.
IC = 10mA at 0.2V saturation voltage
The safety value of RC= 470
Ω
D1 is the reverse protection diode. As if the red and black wires reversely connect with the
power source, the current will flow through the ground via IC and coils L1 and L2 to power
supply. Under such kind of circumstances, the IC and coils are easy to be burned out.
Therefore, D1, the reverse protection diode, is necessary for the design. However, D1 will
also cause an extra voltage drop on the supply voltage.
C1 is a capacitor to reduce the ripple noise caused during the transient of the output stages.
The volume of the ripple noise depends on the coil impedance and characteristics.
+Vcc
D1
R wire
C1
B wire
VCC
NO
L1
FS319
+Vc
SO
GND
Rc
FG
Output
Y wire
Internal circuit of single-phase DC motor
Fig 7 Application Circuit
Rev0.3 Dec.29, 2005(LF)
P
10/FS319
FS319
Technology
PACKAGE DIMENSION Unit:mm
SIP-4L(Lead Free)
5.23±0.12
1.55±0.25
0.73±0.03
4.2±0.1
0.457±0.025
0.38±0.05
0.39±0.05
1.27±0.025
Rev0.3 Dec.29, 2005(LF)
11/FS319
P
FS319
Technology
BAG & BOX DIMENSION
160 mm
100 mm
FTC Logo
BAG LABEL
BAG
BOX
LABEL
630 mm
190 mm
INSIDE BOX
400mm
650mm
CARTON
LABEL
FTC Logo
CARTON
PACKING QUANTITY SPECIFICATIONS
1000 EA /1 BAG
25 BAGS /1 INSIDE BOX
4 INSIDE BOXES /1 CARTON
Rev0.3 Dec.29, 2005(LF)
12/FS319
P
FS319
Technology
LABEL SPECIFICATIONS
7.5 cm
Feeling Technology Corp.
Product Type:
FS319 - X
Lot No:
XXXXXXXXX
XXX
5.5 cm
Date Code:
Package Type:
Marking Type:
Tatal Q'ty:
SIP- 4L
XXXXX
無鉛
Lead Free
XXXXX
BAG LABEL, INSIDE BOX & CARTON LABEL
ORDER INFORMATION
Part Number
Operating Temperature
Package
Description
-20oC
-20oC
-20oC
~
~
~
+85 oC
+85 oC
+85 oC
FS319LF-A
TO-92SP-4
±65G (B)
FS319LF-B
FS319LF-C
TO-92SP-4
TO-92SP-4
±80G (B)
±120G (B)
Rev0.3 Dec.29, 2005(LF)
P
13/FS319
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明