2S7A_1505S1RP [GAPTEC]
2W Single Output - Fixed Input - Isolated & Regulated SIP PACKAGE;型号: | 2S7A_1505S1RP |
厂家: | GAPTEC |
描述: | 2W Single Output - Fixed Input - Isolated & Regulated SIP PACKAGE |
文件: | 总3页 (文件大小:811K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
2S7A_1RP Series
2W Single Output - Fixed Input - Isolated & Regulated
SIP PACKAGE
DC-DC Converter
2 Watt
Small Footprint
SIP Package
Low Ripple and good EMC
features
Temperature Range:
-40°C ~ +85°C
No External Component
Required
1KVDC Isolation
Internal SMD construction
Continuous Short Circuit
Protection (SCP)
Industry Standard Pinout
RoHS Compliance
The 2S7A Series is specially designed for applications where a group of
polar power supplies are isolated from the input power supply in a dis-
tributed power supply system on a circuit board.
These products apply to:
1)Where the voltage of the input power supply is fixed
(voltage variation ≤±±5)ꢀ
2)Where isolation is necessary between input and output
(isolation voltage ≤1000VDC)ꢀ
No Heat Sink Required
3)Where the regulation of the output voltage and the output ripple
and noise are demanded.
Common specifications
Short circuit protection:
Temperature rise at full load:
Cooling:
Output specifications
Continuous, self-recovery
60°C MAX, 40°C TYP
Free air convection
-40°C – +8±°C
Item
Test condition
Min Typ
±0.±
Max
Units
5
Line regulation
Load regulation
For Vin change of ±±5
105 to 1005 full load
1005 full load
±1
±2
±3
5
Operation temperature range:
Storage temperature range:
Lead temperature
Output voltage
accuracy
5
-±±°C – +12±°C
Temperature drift
Ripple*
1005 full load
±0.03 5/°C
300°C (1.±mm from case for 10 sec.)
< 9±5
20MHz Bandwidth
20MHz Bandwidth
20
30
mVp-p
mVp-p
KHz
Storage humidity range:
Case material:
Noise*
±0
1±0
300
Plastic [UL94-V0]
>3,±00,000 hours
2.4g
Switching frequency Full load, nominal
input
100
MTBF (MIL-HDBK-217F@2±°C):
Weight:
*Test ripple and noise by “parallel cable” method. See detailed operation
instructions at Testing of Power Converter section, application notes.
Isolation specifications
Model selection:
WCTP**_xxyyN##O
W=Wattꢀ C= Caseꢀ T=Typeꢀ P=Pinningꢀ **= Voltage Variation (omitted
± 105)ꢀ xx= Vinꢀ yy= Voutꢀ N= Numbers of Outputꢀ ##= Isolation
(kVDC)ꢀ O= output regulation
Item
Test condition
Min
Typ
60
Max
Units
VDC
MΩ
pF
Isolation voltage
Isolation resistance
Tested for 1 minute
Test at ±00VDC
1000
1000
Isolation capacitance Input-Output,
100KHz/0.1V
Example:
2S7A_0505S1RP
2= 2Watt; S7= SIP7; A= Pinning; 5Vin; 5Vout; S= Single Output;
1= 1kVDC; R= Regulated Output; P= Short Circuit Protection
Note:
1. Operation under minimum load will not damage the converterꢀ However, they
may not meet all specification listed, and that will reduce the life of product.
2. All specifications measured at Ta=2±°C, humidity<7±5, nominal input voltage
and rated output load unless otherwise specified.
3. In this datasheet, all the test methods of indications are based on corporate
standards.
4. Only typical models listed, other models may be different, please contact our
technical person for more details.
Part Number
Input Voltage
[V]
Output Voltage
[VDC]
Output Current [mA, max]
Input Current [mA, max]
Efficiency [%, typ]
Max.
400
1±0
400
133
400
400
Min.
40
1±
40
13
40
40
Max. load
Min. load
2S7A_0±0±S1RP
2S7A_0±12S1RP
2S7A_120±S1RP
2S7A_121±S1RP
2S7A_1±0±S1RP
2S7A_240±S1RP
±
±
12
±
±80
2±
2±
20
20
1±
8
69
71
70
72
70
70
±
±07
12
12
1±
24
238
1±
±
231
190
±
119
Page 1 of 3
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
2S7A_1RP – Rev. 2016-1.0
Specifications subject to change without notice.
2S7A_1RP Series
2W - Single Output - Fixed Input - Isolated & Regulated
SIP PACKAGE
Typical characteristics
Mechanical Dimensions
Note:
Unit: mm[inch]
Pin section tolerances: ±0.10mm [±0.004inch]
General tolerances: ±0.2±mm [±0.010inch]
Page 2 of 3
2S7A_1RP – Rev. 2016-1.0
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
Specifications subject to change without notice.
2S7A_1RP Series
2W - Single Output - Fixed Input - Isolated & Regulated
SIP PACKAGE
Application note
1) Requirement on output load
To ensure this module can operate efficiently and reliably, During opera-
tion, the minimum output load could not be less than 105 of the full
load. If the actual output power is very small, please connect a resistor
with proper resistance at the output end in parallel to increase the load.
Vin
(VDC)
Cin
(uF)
Single Vout
(VDC)
Cout
(uF)
±
4.7
2.2
1
±
12
1±
--
4.7
2.2
1
12
1±
24
2) Recommended testing and application circuit
If you want to further decrease the input/output ripple, an “LC” filtering
network may be connected to the input and output ends of the DC/DC
converter, see (Figure 1).
0.47
--
3) Input Over-voltage Protection Circuit
The simplest device for input over-voltage protection is a linear voltage
regulator with overheat protection that is connected to the input end in
series (Figure 2).
Figure 1
It should also be noted that the inductance and the frequency of the
“LC” filtering network should be staggered with the DC/DC frequency to
avoid mutual interference. However, the capacitance of the output filter
capacitor must be proper. If the capacitance is too big, a startup prob-
lem might arise. For every channel of output, provided the safe and reli-
able operation is ensured, the greatest capacitance of its filter capacitor
sees (Table 1).
Figure 2
4) Overload Protection
Under normal operating conditions, the output circuit of these products
has no protection against overload. The simplest method is to connect
self-recovery fuse in series at the input end or add a circuit breaker to
the circuit.
5) When the environment temperature is higher than 71°C, the product
output power should be less then 60% of the rated power.
6) It is not recommended to increase the output power capability by
connecting two or more converters in parallel. The product is not hot-
swappable.
Page 3 of 3
2S7A_1RP – Rev. 2016-1.0
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
Specifications subject to change without notice.
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明