LMS78_15-1.0R [GAPTEC]
Wide Input Non-Isolated & Regulated, Single Positive/Negative Output;型号: | LMS78_15-1.0R |
厂家: | GAPTEC |
描述: | Wide Input Non-Isolated & Regulated, Single Positive/Negative Output |
文件: | 总4页 (文件大小:876K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
LMS78_1.0R Series
Wide Input Non-Isolated & Regulated, Single Positive/Negative Output
Switching Regulator
Efficiency up to 96%
Operating temperature:
-40°C ~ +85°C
Pin-out compatible with
LM78xx linear regulator
Short circuit protection (SCP)
No-load input current as low
as 0.1mA
Low ripple and noise
Subminiature SIP package
Meeting UL60950, EN60950
standards
No heatsink required
Industry standard pinout
MTBF>2,000,000 hours
Supporting negative output
perfectly
The LMS78_1.0R series are high efficiency switching regulators and ideal
substitutes of LM78XX series three-terminal linear regulators.
The product is featured with high efficiency, low loss, low radiation and
no heat sink requirement. They are widely used in industrial control,
instrumentation, and electric power applications.
UL-60950-1 (E347551)
Common specifications
Short circuit protection:
No-load power consumption:
Reverse Polarity Input:
Input Filter:
Output specifications
Continuous, automatic recovery
0.1mA TYP, 1mA MAX
Forbidden
Item
Test conditions
Min
Typ
Max
Units
Output voltage
accuracy
100% load
• LMS78_03-1.0R
• others
2
2
4
3
%
%
Capacitor Filter
Line regulation
Load regulation
Ripple + Noise*
Input Voltage Range
10% to 100% load
20MHz Bandwidth
0.2
0.4
20
0.4
0.6
75
%
%
Temperature rise at full load:
Cooling:
25°C MAX, 15°C TYP
Free air convection
mVp-
p
Operation temperature range:
-40°C~+85°C
Power derating above 71°C
Switching frequency • 3.3V/5V output
• others
420
580
520
680
620
780
KHz
KHz
Storage temperature range:
Pin welding resistance temperature:
Operating case temperature:
Storage humidity range:
Package material:
-55°C ~+125°C
Transient response
deviation
Nominal input, 25%
load step change
50
300
mV
260°C MAX, 1.5mm from case for 10 sec
100°C
Transient recovery
time
Nominal input, 25%
load step change
0.1
1
ms
< 95%RH
Plastic [UL94-V0]
Temperature
coefficient
-40 °C to +85 °C
ambient
0.03
%/°C
MTBF:
>2,000,000 hours
+25°C MIL-HDBK-217F
* Test ripple and noise by “parallel cable” method. With the load lower than 10%,
maximum ripple and noise will be 150mVp-p.
Weight:
3.8g
Note:
1. The max. capacitive load should be tested within the input voltage range and
under full load conditions;
Example:
LMS78_05-1.0RL
2. Without any special statement, all indexes are only specific to positive output
application;
LM = Series; S = SIP Case; 05 = 5Vout; 1.0 = 1.0A; R = Revised;
L = Bended Pins
3. Unless otherwise specified, data in this datasheet should be tested under the
conditions of Ta = 25°C, humidity <75% when inputting nominal voltage and
outputting rated load;
4. All index testing methods in this datasheet are based on our Company’s
corporate standards;
5. The performance indexes of the product models listed in this manual are as
above, but some indexes of non-standard model products will exceed the
above-mentioned requirements, and please directly contact with our technician
for specific information;
6. Specifications subject to change without prior notice.
EMC specifications
EMI
CE
CISPR22/EN55022
CISPR22/EN55022
IEC/EN61000-4-2
IEC/EN61000-4-3
IEC/EN61000-4-4
IEC/EN61000-4-5
IEC/EN61000-4-6
CLASS B
CLASS B
(External circuit refer to EMC recommended circuit, 2 )
(External circuit refer to EMC recommended circuit, 2 )
EMI
RE
EMS
EMS
EMS
EMS
EMS
ESD
RS
Contact 4KV perf. Criteria B
10V/m
1KV
perf. Criteria A
EFT
Surge
CS
perf. Criteria B (External circuit refer to EMC recommended circuit, 1 )
perf. Criteria B (External circuit refer to EMC recommended circuit, 1 )
perf. Criteria A
1KV
3 Vr.m.s
Page 1 of 4
LMS78_1.0R – Rev. 2020-1.2
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
LMS78_1.0R Series
Wide Input Non-Isolated & Regulated, Single Positive/Negative Output
Part Number
Input Voltage [VDC]
Nominal (Range)
Output Voltage
[VDC]
Output Current
Efficiency
Max. capacitive load
[µF]
External capacitor table
[mA]
[%, min/max]
LMS78_03-1.0R
LMS78_05-1.0R
24 (6-36)
3.3
1000
90/81
680
24 (8-36)
12 (8-27)
5.0
-5.0
1000
-500
93/86
86/82
680
330
LMS78_09-1.0R
LMS78_12-1.0R
24 (13-36)
9.0
1000
95/90
680
24 (16~36)
12 (8-20)
12
-12
1000
-300
96/93
89/88
680
330
LMS78_15-1.0R
24 (20-36)
12 (8-18)
15
-15
1000
-300
96/94
89/89
680
330
Add suffix “L” for 90° bend pins, for example: LMS78_05-1.0RL.
Typical characteristics
Typical application circuit
Part Number
C1,C3
(Ceramic Capacitor)
C2,C4
(Ceramic Capacitor)
LMS78_03-1.0R
LMS78_05-1.0R
LMS78_09-1.0R
LMS78_12-1.0R
LMS78_15-1.0R
10μF/50V
22μF/10V
10μF/50V
22μF/10V
10μF/50V
10μF/16V
10μF/50V
10μF/25V
10μF/50V
10μF/25V
Note:
1. C1 and C2 (C3 and C4) are required and should be connected close to the pin
terminal of the module.
2. The capacitance of C1 and C2 (C3 and C4) refer to Sheet 1.
3. To reduce the output ripple furtherly. C2 and C4 can be increased properly if
required, and tantalum or low ESR electrolytic capacitors may also suffice.
4. When the products used as positive and negative output parallelling appli-
cation circuit, an inductor named as LDM up to 10μH is recommended in the
circuit to reduce the mutual interference.
5. Cannot be used in parallel for output and hot swap.
Page 2 of 4
LMS78_1.0R – Rev. 2020-1.2
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
LMS78_1.0R Series
Wide Input Non-Isolated & Regulated, Single Positive/Negative Output
Standard application circuit
LMS78_15-1.0R
LMS78_05-1.0R
LMS78_15-1.0R
LMS78_05-1.0R
LMS78_15-1.0R
LMS78_05-1.0R
LMS78_15-1.0R
LMS78_05-1.0R
EMC solution-recommended circuit
Part 1 is for EMS test, part 2 is for EMI filtering; parts 1 and 2 can be
added based on actual requirement.
FUSE
MOV
LDM1
82μH
C0
C1/C2
C3
LDM2
12μH
Selected based on the
actual input current
from the customer
S20K30
680μF /50V
Refer to positive
output application
circuit
4.7μF /50V
Page 3 of 4
LMS78_1.0R – Rev. 2020-1.2
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
LMS78_1.0R Series
Wide Input Non-Isolated & Regulated, Single Positive/Negative Output
Mechanical dimension and footprint
LMS78_xx-1.0R
LMS78_xx-1.0RL
LMS78_xx-1.0R
LMS78_xx-1.0R
Page 4 of 4
LMS78_1.0R – Rev. 2020-1.2
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明