MD112MD12HI [MPD]
MD100MHI SERIES;型号: | MD112MD12HI |
厂家: | MICROPOWER DIRECT, LLC |
描述: | MD100MHI SERIES |
文件: | 总2页 (文件大小:287K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Series
MD100MHI
Miniature, 1W SIP
Medical Approved
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Key Features:
• 1W Output Power
Conditions
Min.
Typ.
5.0
Max.
5.5
Units
5 VDC Input
4.5
Input Voltage Range
VDC
• 3 kVAC rms Isolation
12 VDC Input 10.8
LC Filter
12.0
13.2
Input Filter
• Reinforced Insulation
• Miniature SIP Case
• Single & Dual Outputs
• 12 Standard Models
• 2.0 MH MTBF
• Industry Standard Pin-Out
• EN 60950 Approved
• EN 60601 Approved
Reverse Polarity Input Current
0.3
A
Output
Parameter
Conditions
Min.
Typ.
1.0
0.1
1.2
Max.
3.0
Units
%
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
Dual Output , Balanced Loads
For Vin Change of 1%
1.0
%
1.5
%
Load Regulation, See Note 1
Ripple & Noise (20 MHz), See Note 2
Ripple & Noise (20 MHz)
Ripple & Noise (20 MHz)
Temperature Coefficient
Output Short Circuit
General
See Model Selection Guide
100
0.01
Typ.
150
200
15
mV P - P
mV P - P
mV rms
%/°C
Over Line, Load & Temp.
0.02
Momentary (0.5 Sec.)
Parameter
Conditions
Min.
Max.
Units
VAC rms
VPk
Isolation Voltage
60 Seconds 3,000
Isolation Test Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
Environmental
Parameter
Flash Tested for 1 Sec 4,500
500 VDC
10
G
100 kHz, 1V
15
80
20
pF
50
100
kHz
Conditions
Min.
Typ.
Max.
+85
Units
°C
Operating Temperature Range
Operating Temperature Range
Storage Temperature Range
Cooling
Ambient -25
Case
+90
°C
-50
+125
°C
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.87 x 0.30 x 0.49 Inches (22.0 x 7.5 x 12.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.13 Oz (3.9g)
Case Material
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Weight
Reliability Specifications
Parameter
Conditions
Min.
Typ.
Max.
Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign
2.0
MHours
Safety Approvals
Absolute Maximum Ratings
Parameter
UL 60601, UL 60950, EN 60601, EN 60950
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Conditions
Min.
5 VDC Input -0.7
12 VDC Input -0.7
Typ.
Max.
9.0
Units
Input Voltage Surge (1 Sec)
VDC
29.0
260
650
Lead Temperature
1.5 mm From Case For 10 Sec
All Models
°C
Internal Power Dissipation
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
Model Selection Guide
www.micropowerdirect.com
Input
Output
Load
Fuse Rating
Slow-Blow
(mA)
Model
Number
Efficiency
(%, Typ)
Voltage (VDC)
Current (mA)
Regulation
(%, Max)
Voltage Current
Current
(mA, Min)
(VDC)
(mA, Max)
Nominal Range
Full-Load No-Load
MD105MS-05HI
MD105MS-12HI
MD105MS-15HI
MD105MD-05HI
MD105MD-12HI
MD105MD-15HI
MD112MS-05HI
MD112MS-12HI
MD112MS-15HI
MD112MD-05HI
MD112MD-12HI
MD112MD-15HI
Notes:
5
5
4.5 - 5.5
4.5 - 5.5
303
291
295
303
267
287
126
121
123
126
108
117
55
55
55
55
55
55
30
30
30
30
30
30
5.0
12.0
15.0
5.0
200.0
80.0
65.0
100.0
40.0
35.0
200.0
80.0
65.0
100.0
40.0
35.0
4.0
2.0
1.0
2.0
1.0
1.0
4.0
2.0
1.0
2.0
1.0
1.0
10
8
66
66
66
66
72
73
66
66
66
66
74
75
500
500
500
500
500
500
200
200
200
200
200
200
5
4.5 - 5.5
8
5
4.5 - 5.5
10
8
5
4.5 - 5.5
12.0
15.0
5.0
5
4.5 - 5.5
8
12
12
12
12
12
12
10.8 - 13.2
10.8 - 13.2
10.8 - 13.2
10.8 - 13.2
10.8 - 13.2
10.8 - 13.2
10
8
12.0
15.0
5.0
8
10
8
12.0
15.0
8
Derating Curve
0. Output load regulation is specified for a load change of 2±% to 0±±%.
2. When measuring output ripple, it is recomended that an external ±.33 µF
ceramic capacitor be placed from the +Vout pin to the -Vout pin for single
output units and from each output to common for dual output units.
3. Operation at no-load will not damage these units. However, they may not meet
all specifications.
4. Dual output units may be connected to provide a 0± VDC, 24 VDC or 3± VDC
output. To do this, connect the load across the positive (+Vout) and negative
(-Vout) outputs and float the output common.
5. It is recommended that a fuse be used on the input of a power supply for
protection. See the table above for the correct rating.
Mechanical Dimensions
Pin Connections
Pin
Single
Dual
1
+Vin
+Vin
2
-Vin
-Vin
5
-Vout
No Pin
+Vout
-Vout
6
Common
+Vout
7
NC: No Connection
Capacitive Load
Single Output
Dual Output
µF Max
µF Max
680
220
Mechanical Notes:
• All dimensions are typical in inches (mm)
• Tolerance x.xx = ±±.±0 (±±.25)
MicroPower Direct
We Power Your Success - For Less!
292 Page Street Ste D Stoughton, MA 02072
•
TEL: (781) 344-8226
•
FAX: (781) 344-8481
•
E-Mail: sales@micropowerdirect.com
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明