MPA301DX-0512Z [MPD]

Smallest 1U Height 300W, Active PFC Dual Output AC/DC Power Supplies; 最小高度1U 300W ，采用主动式PFC双输出AC / DC电源


型号：	MPA301DX-0512Z
厂家：	MICROPOWER DIRECT, LLC
描述：	Smallest 1U Height 300W, Active PFC Dual Output AC/DC Power Supplies 最小高度1U 300W ，采用主动式PFC双输出AC / DC电源功率因数校正
文件：	总2页 (文件大小：399K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

MPA301D_Series

Smallest 1U Height

Only

300W, Active PFC

6 x 4 x 1.5

Inches!!

Dual Output

AC/DC Power Supplies

Electrical Speciﬁcations

Key Features:

Speciﬁcations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Speciﬁcations subject to change without notice.

• Smallest 1U 300W Supply

• Dual Outputs

Input

Parameter

Input Voltage Range

Input Frequency

Conditions

Min.

Typ.

Max.

264

Units

VAC

• PFC to EN61000-3-2 “D”

• Universal AC Input

• UL, cUL, TUV Approvals

• CE Certiﬁed

• FCC Class B Emissions

• 700W Peak Power

• Four Mechanical Options

Universal

100 - 120 VAC

200 - 240 VAC

110 VAC

Input Current, Full Load

Inrush Current, Cold Start

220 VAC

Leakage Current

Power Factor Correction

Input Protection

240 VAC

3.5

Meets EN61000-3-2 Class D

T8A/250V Fuse

Output

Parameter

Conditions

V1 By Trim Pot

Min.

Typ.

5.0

Max.

Units

Output Voltage Adjustment

Output Regulation (Note 1)

Hold Time

110 VAC, 80% Load

mSec

Ripple & Noise (20 MHz) (Note 2)

Overload Protection

Over Voltage Protection

Over Temperature Protection

Temperature Coefﬁcient

Transient Recovery Time (Note 3)

Transient Response Deviation

Overshoot/Undershoot

Turn On Delay

See Model Selection Guide

Power Limit 110

>130% of Rated Output Voltage. Recycle AC Input.

140

+85

0.04

ºC

%/ºC

2.5

50% Load Change

At Turn On/Off

5.0

120 VAC

Output Short Circuit

General

Continuous With Autorecovery

Parameter

Conditions

Min.

Typ.

Max.

Units

VAC

kHz

Input - Output 3,000

Input - FG (Frame Ground) 1,500

Primary - Core 1,500

Fixed

Isolation Voltage (Note 4)

Switching Frequency

Interface Signals

Power Supply On

MicroPower Direct

292 Page Street

Suite D

Stoughton, MA 02072

USA

Green LED (LED1) on the PCB

PG on CN1. Goes TTL high 100 to 500 mS after regulation. Goes low at

least 1 mS before the loss of regulation. Will sink 100 mA.

FF on pin 3 of CN1. Open collector output rated for 15 VDC/5 mA sink

current maximum. Goes high if a fan failure is detected

Power Good Signal

Fan Fail

Environmental

Parameter

Operating Temperature Range

Output Derating

Storage Temperature Range

Cooling

Operating Humidity

Reliability Speciﬁcations

Parameter

T: (781) 344-8226

F: (781) 344-8481

E: sales@micropowerdirect.com

W: www.micropowerdirect.com

Conditions

Min.

Typ.

+25

Max.

+50

Units

ºC

Ambient

2.5%/ ºC from +50 ºC to + 70 ºC

-20

See Model Selection Guide

+85

ºC

RH, Non-condensing

Conditions

MIL HDBK 217F, 30ºC, Gnd Benign

Min.

100

Typ.

Max.

Units

kHours

MTBF

Safety Standards

EEMI Compliance

EMS Immunity Compliance

UL 60950; CSA C22.2 No. 60950; TUV EN60950; CB Report (IEC 60950)

Compliance to EN55022 (CISPR22) Class B; EN61000-3-2,3

EN6100-4-2,3,4,5,6,8,11; EN55024,; CE Marked (LVD)

Model Selection Guide

Input & Output Connector CN2:

Howder Terminal Block No. HB-95-7P or

Mating Molex Part No. 09-91-1600 (16 pin)

Max. Output Current (Note 6)

Model

Number

Output Voltage

Factory

Ripple &

Noise

Efﬁciency

18 CFM

(U/w Air, E, F)

Convection

(U)

Output Pin Assignment:

+5 VDC

+12 VDC

+5 VDC

+24 VDC

+5 VDC

+48 VDC

+12 VDC

+24 VDC

30.00A

16.67A

30.00A

8.33A

15.00A

10.42A

15.00A

5.20A

1% p-p

MPA301Dx-0512z

MPA301Dx-0524z

MPA301Dx-0548z

75%

Howder

Molex

Pins 1 ~ 3: V1

Pins 1: V1

Pins 2 ~ 3: RTN Pins 4 ~ 8: RTN

Pin 4: V2

Pin 5: GND

Pin 6: Neutral

Pin 7: Line

Pins 9 ~ 10: V2

Pin 12: GND

30.00A

4.16A

15.00A

2.60A

Pin 14: Neutral

Pin 16: Line

16.67A

8.33A

12.50A

6.25A

MPA301Dx-1224z

Notes:

to other levels within the range without affecting the agency

certiﬁcation. For more information, contact the factory.

6. The maximum continuous output power level, (combined for

V1 & V2) is 300W (with 28.5 CFM) for the MPA301Dx-1224

& 250W for all other models. For convection cooling, the maxi-

mum continuous output power level (combined for V1 & V2) is

150W for the MPA301Dx-1224 & 125W for all other models.

For more information, contact the factory.

Logic Signal Connector CN1:

1. Output regulation includes line & load.

Mating JST XHP-3 or equivalent (CHYAO

SHIUNN JS-21001-3) Mating Pins: JST

SXH-002T-P0.6 for AWG 30 to 26.

2. Ripple & noise is measured from 10 Hz to 20 MHz. Measurement connec-

tion to the unit is made with a 0.1 µF ceramic capacitor & a 22 µF electrolytic

capacitor connected in parallel.

3. Transient recovery is measured to within a 1% error band for a load step

change of 50% to 100%.

Fan driver connector (FAN2):

12 VDC / 400 mA is available to drive an external

fan. Mating connector is a JST XHP-2 or Molex P/N

48-151-0210 ( 2 pins 0.98 pitch). Mating Pins: JST

SXH-001T-P0.62T or Molex 48150 .

4. Isolation speciﬁcations are production HI-Pot tested for 3 seconds.

5. The full output range (see table above) is covered in the safety agency certiﬁca- 7. A10%minimumloadisrequiredtomaintainregulationand ripple

tion. Standard models are factory set to the “Preset” voltage.This may be set

speciﬁcations.

Mechanical Dimensions: U-Chassis (U Sufﬁx)

U-Chassis Cover (C Sufﬁx)

Enclosure With End Fan (E Sufﬁx)

Enclosure With Top Fan (F Sufﬁx)

MicroPower Direct

FAX: (781) 344-8481

www.micropowerdirect.com

292 Page Street Ste D Stoughton, MA 02072

•

TEL: (781) 344-8226

•

E-Mail: sales@micropowerdirect.com

相关型号：