MPA320X-09Z [MPD]

Smallest 1U 320W Single Output Power Factor Corrected AC/DC Power Supplies; 最小的1U 320W单路输出功率因数校正AC / DC电源
MPA320X-09Z
型号: MPA320X-09Z
厂家: MICROPOWER DIRECT, LLC    MICROPOWER DIRECT, LLC
描述:

Smallest 1U 320W Single Output Power Factor Corrected AC/DC Power Supplies
最小的1U 320W单路输出功率因数校正AC / DC电源

功率因数校正
文件: 总2页 (文件大小:393K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
MPA320 Series  
Smallest 1U 320W  
Single Output  
Only  
6 x 4 x 1.5  
Inches!!  
Power Factor Corrected  
AC/DC Power Supplies  
Electrical Specifications  
Key Features:  
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.  
Smallest 1U 320W Supply  
PFC to EN61000-3-2 “A”  
UL, cUL, TUV Approvals  
CE Certified  
Input  
Parameter  
Conditions  
Autoranging  
Min.  
90  
180  
47  
Typ.  
Max.  
132  
264  
63  
Units  
VAC  
Hz  
Input Voltage Range  
Input Frequency  
FCC Class B Emissions  
2 - 60 V Output Voltages  
Auto Selectable AC Input  
700W Peak Power  
100 - 120 VAC  
200 - 240 VAC  
110 VAC  
8
4
Input Current, Full Load  
A
35  
70  
Inrush Current, Cold Start  
A
220 VAC  
240 VAC  
Four Mechanical Options  
Leakage Current (Note 1)  
Power Factor Correction  
Input Protection  
1.5  
mA  
Meets EN61000-3-2 Class A  
T8A/250V Fuse  
Output  
Parameter  
Conditions  
Min.  
Typ.  
5.0  
1.0  
20  
Max.  
Units  
%
%
Output Voltage Adjustment  
Output Regulation (Note 2)  
Hold Time  
By Trim Pot  
110 VAC, 80% Load  
mSec  
Ripple & Noise (20 MHz) (Note 3)  
Overload Protection  
Over Voltage Protection  
Over Temperature Protection  
Temperature Coefficient  
Transient Recovery Time (Note 4)  
Transient Response Deviation  
Overshoot/Undershoot  
Turn On Delay  
See Model Selection Guide  
Power Limit 130  
>130% of Rated Output Voltage. Recycle AC Input.  
160  
%
0.04  
%/ºC  
mS  
%
%
S
2.5  
5
50% Load Change  
At Turn On/Off  
5.0  
1
120 VAC  
Output Short Circuit  
General  
Continuous With Autorecovery  
Parameter  
Conditions  
Min.  
Typ.  
Max.  
Units  
VAC  
kHz  
Input - Output 3,000  
Input - FG (Frame Ground) 1,500  
Primary - Core 1,500  
Fixed  
Isolation Voltage (Note 5)  
Switching Frequency  
Interface Signals  
Power Supply On  
23  
MicroPower Direct  
292 Page Street  
Suite D  
Stoughton, MA 02072  
USA  
Green LED (LED1) on the PCB  
PG on CN1. Goes TTL high 100 to 500 mS after regulation. Goes low at  
least 1 mS before the loss of regulation. Will sink 100 mA.  
FF on pin 3 of CN1. Open collector output rated for 15 VDC/5 mA sink  
current maximum. Goes high if a fan failure is detected  
Power Good Signal  
Fan Fail  
T: (781) 344-8226  
F: (781) 344-8481  
E: sales@micropowerdirect.com  
W: www.micropowerdirect.com  
Environmental  
Parameter  
Operating Temperature Range  
Output Derating  
Storage Temperature Range  
Cooling  
Operating Humidity  
Reliability Specifications  
Parameter  
Conditions  
Min.  
Typ.  
Max.  
Units  
Ambient  
0
+25  
+50  
ºC  
2.5%/ ºC from +50 ºC to + 70 ºC  
-20  
See Model Selection Guide  
+85  
90  
ºC  
%
RH, Non-condensing  
Conditions  
MIL HDBK 217F, 30ºC, Gnd Benign  
Min.  
100  
Typ.  
Max.  
Units  
kHours  
MTBF  
Safety Standards  
EEMI Compliance  
EMS Immunity Compliance  
UL 60950; CSA C22.2 No. 60950; TUV EN60950; CB Report (IEC 60950)  
Compliance to EN55022 (CISPR22) Class B; EN61000-3-2,3  
EN6100-4-2,3,4,5,6,8,11; EN55024,; CE Marked (LVD)  
Model Selection Guide  
Input & Output Connector CN2:  
Howder Terminal Block No. HB-95-7P or  
Mating Molex Part No. 09-91-1600 (16 pin)  
Output Voltage  
Max. Output Current (Notes 7, 8)  
“U, E, F” Units “U” Units “C” Units  
Convection Convection  
Model  
Number  
Ripple &  
Noise  
Efficiency  
(Note 7)  
Factory  
Range  
PreSet  
5 VDC  
9 VDC  
22 CFM  
45.00A  
29.10A  
26.66A  
21.33A  
17.77A  
13.33A  
11.42A  
8.88A  
Output Pin Assignment:  
MPA320x-05z  
MPA320x-09z  
2.0 - 5.5 VDC  
6.0 - 11.0 VDC  
27.28A  
16.37A  
15.00A  
12.00A  
10.00A  
7.50A  
6.42A  
5.00A  
3.75A  
3.33A  
25.00A  
13.64A  
14.16A  
11.33A  
9.44A  
7.08A  
6.07A  
4.72A  
3.54A  
3.14A  
50 mV p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
1% p-p  
75%  
80%  
83%  
83%  
83%  
83%  
83%  
83%  
83%  
83%  
Howder  
Molex  
Pins 1 ~ 2: V+  
Pins 3 ~ 4: V-  
Pin 5: Grnd  
Pin 6: Neutral  
Pin 7: Line  
Pins 1 ~ 5: V+  
Pins 6 ~ 10: V-  
Pin 12: Grnd  
Pin 14: Neutral  
Pin 16: Line  
MPA320x-12z 12 VDC 12.0 - 13.5 VDC  
MPA320x-15z 15 VDC 13.6 - 15.0 VDC  
MPA320x-18z 18 VDC 16.0 - 20.0 VDC  
MPA320x-24z 24 VDC 21.0 - 26.0 VDC  
MPA320x-28z 28 VDC 27.0 - 34.0 VDC  
MPA320x-36z 36 VDC 35.0 - 42.0 VDC  
MPA320x-48z 48 VDC 43.0 - 50.0 VDC  
MPA320x-54z 54 VDC 51.0 - 60.0 VDC  
Logic Signal Connector CN1:  
6.66A  
5.92A  
Mating JST XHP or equivalent (CHYAO  
SHIUNN JS-21001-3) Mating Pins: JST  
SXH-002T-P0.6 for AWG 30 to 26.  
Notes:  
6. The full output range (see table above) is covered in the safety agency certification. Stan-  
dard models are factory set to the “Preset” voltage.This may be set to other levels within  
the range without affecting the agency certification. Contact the factory for details.  
7. Output current is given for the factory preset voltage.With the exception of the “05”  
output model, the maximum continuous output power level is 320W (with 22 CFM),  
180W (U-Chassis convection cooled) or 170W (“C” units convection cooled. For more  
information, contact the factory.  
8. Units will provide peak power of 700W for 500 μS. For units capable of longer durations,  
contact the factory.  
9. A 1% minimum load is required to maintain regulation and ripple specifications.  
1. Models are available with leakage current specified as low as 500 μA  
(at 240 VAC) / 300 μA (at 120 VAC). Contact the factory for details.  
2. Output regulation includes line & load.  
Fan driver connector (FAN2):  
12 VDC / 400 mA is available to drive an  
external fan. Mating connector is a JST  
XHP-2 or Molex P/N 48-151-0210 ( 2 pins  
0.98 pitch). Mating Pins: JST SXH-001T-  
P0.62T or Molex 48150 .  
3. Ripple & noise is measured from 10 Hz to 20 MHz. Measurement  
connection to the unit is made with a 0.1 μF ceramic capacitor & a 22  
μF electrolytic capacitor connected in parallel.  
4. Transient recovery is measured to within a 1% error band for a load  
step change of 50% to 100%.  
5. Isolation specifications are production HI-Pot tested for 3 seconds.  
Mechanical Dimensions: U-Chassis (U Suffix)  
U-Chassis Cover (C Suffix)  
Enclosure With End Fan (E Suffix)  
Enclosure With Top Fan (F Suffix)  
MicroPower Direct  
FAX: (781) 344-8481  
www.micropowerdirect.com  
292 Page Street Ste D Stoughton, MA 02072  
TEL: (781) 344-8226  
E-Mail: sales@micropowerdirect.com  

相关型号:

SI9130DB

5- and 3.3-V Step-Down Synchronous Converters

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1-E3

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135_11

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9136_11

Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130CG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130LG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130_11

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137DB

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137LG

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9122E

500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification Drivers

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY