NSVS1108 [NJRC]

SAW Filter, 1 Function(s), 1227.6MHz, FLIP-CHIP-6;


型号：	NSVS1108
厂家：	NEW JAPAN RADIO
描述：	SAW Filter, 1 Function(s), 1227.6MHz, FLIP-CHIP-6 LTE
文件：	总4页 (文件大小：89K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

NSVS1108 Apr. 2013

NewJRC SAW FILTER

NSVS1108

Application

GPS L2

Electrical Specification: (Table 1)

The device characteristics are measured in the circuit shown in Fig.1.

Table 1. Electrical Specifications

Item

Spec.

Typical

50Ω

1227.6MHz

2.8dB

1.0dB

2.0

Input and Output Impedance

Nominal Center Frequency (f0)

Insertion Loss

1217.6~1237.6MHz

3.5dB max.

1.5dB max.

1.5 max.

40dB min.

35dB min.

17dB min.

18dB min.

30dB min.

35dB min.

27dB min.

20dB min.

Response Variation

Input and Output VSWR 1217.6~1237.6MHz

Out of Band Rejection

(Relative to

DC~1088MHz

1088~1178MHz

1178~1193MHz

1263~1278MHz

1278~1368MHz

1368~1785MHz

1785~2500MHz

2500~4000MHz

45dB

40dB

Through Level)

42dB

45dB

38dB

40dB

35dB

30dB

(Operating Temperature Range : -30~+85ºC)

Maximum Rating: (Table 2)

Table2. Maximum Ratings

Item

Rating

Maximum Input Power

Maximum DC Voltage

Operating Temperature Range

Storage Temperature

+10dBm

7.5V

-30~+85ºC

-40~+90ºC

Mechanical Specifications: (Fig.2)

Package is designed as small as 3.0x3.0x1.15[mm³] for SMD (Surface Mount Device) type.

Notice:

This part is electrostatic discharge sensitive and may be damaged by improper handling.

http://www.njr.co.jp/products/device/index.html

http://www.njr.com/products/device/index.html

(Japanese)

(English)

NSVS1108 Apr. 2013

OUT

50Ω

2 SAW5

Fig.1 Measuring circuit

3. 0±0. 15

(b)

(a)

221

(c)

(1)

(2)

Marking

(1) Lot Number

(a) Year

(b) Month

(0. 6)

*Oct.---

Nov.---

Dec.---

1-9---

10-19---

20-31---

(2) Part Number Mark

(1. 80)

Pin no.

Connection

GND

(0. 75)

[4x]

(0. 45)

IN/OUT

GND

Fig.2 Package dimensions (in mm)

3.8

GND

OUT/IN

GND

2.2

1.15

Fig.3 Desirable land area (in mm)

NSVS1108 Apr. 2013

Notice

1. Use this component within operating temperature range. It might not be

satisfied with electrical specification without operating temperature range.

When it is used less than -30ºC or more than +85ºC, it might be a cause of

degradation or destruction of the component. Even if it endures during a short

time, it causes degradation of qualification.

2. When soldering iron is used, solder with the temperature at the tip of soldering

iron: 350ºC max., the time of soldering: 10 seconds max., the power of

soldering iron: 30W max..

3. Notice that the allowed time of soldering with soldering iron is accumulated

time, when soldering is repeated.

4. As rapid temperature change for cleaning after reflow soldering might be a

cause of destruction clean this component after confirming that temperature of

this component goes down to room temperature.

5. Confirm that there are not any influence for qualification to this component in

mounting on PCB when this component is cleaned.

6. As it might be a cause of degradation of destruction to apply static electricity to

this component, do not apply static electricity or excessive voltage while

assembling and measuring. And do not transport this component with bare

hand.

7. As it might be a cause of degradation or destruction to apply D.C. voltage

between each terminal, apply D.C. voltage 7.5V max. in actual circuit.

Note

1. This specification specifies the quality of this component as a single unit. Make

sure that this component is evaluated and confirmed against this specification

when it is mounted to your products.

NSVS1108 Apr. 2013

FREQUENCY CHARACTERISTICS

S21

CH1 : center 1227.6 span 200

CH2 : center 1227.6 span 200

S11

S22

S11

1127.6

1327.6 1127.6

1327.6

Frequency [MHz]

S21

100

3000

Frequency [MHz]

New Japan Radio Co.,Ltd.

相关型号：