NSVS1196 [NJRC]
1-Port Saw Resonator, 433.92MHz Nom, SMALL, SMD, 6 PIN;
| 型号： | NSVS1196 |
| 厂家： | 
NEW JAPAN RADIO |
| 描述： | 1-Port Saw Resonator, 433.92MHz Nom, SMALL, SMD, 6 PIN 晶体 谐振器 |
| 文件： | 总4页 (文件大小：208K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
NSVS1196 Apr. 2013
NewJRC SAW RESONATOR
NSVS1196
Application
433.92MHz Resonator
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.2.
Table 1. Electrical Specifications
(@25ºC)
Typical
Item
Specification
Center frequency
Absolute frequency
Tolerance from 433.92MHz
@Minimum Loss
-
433.92 MHz
±50kHz max.
-
-
Insertion Loss
2.5 dB max.
Temperature Stability Turnover Temperature
Temperature Coefficient
-
25 ºC
-
-0.04 ppm/ºC2
-
DC Insulation Resistance between any two terminals
1.0M ohm min.
RF Equivalent
RLC Model (fig.1)
Motional Resistance
Motional Inductance
Motional Capacitance
Shunt Static Capacitance
(RM)
(LM)
(CM)
(C0)
-
-
-
-
14.5 ohm
65.595 μH
2.05 fF
2.902 pF
Maximum Rating: (Table 2)
CM
LM
RM
Table2. Maximum Ratings
Item
Rating
0dBm
Maximum Input Power
Operating Temperature Range
Storage Temperature
C0
-40~+85ºC
-40~+85ºC
Fig.1 RF Equivalent RLC Model
Mechanical Specifications: (Fig.2)
Package is designed as small as 3.0x3.0x1.15[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
http://www.njr.co.jp/products/device/index.html
http://www.njr.com/products/device/index.html
(Japanese)
(English)
NSVS1196 Apr. 2013
IN
1
6
50Ω
2 SAW5
3
4
OUT
50Ω
Fig.1 Measuring circuit
3. 0±0. 15
(b)
(a)
221
(c)
(1)
SF
(2)
Marking
(1) Lot Number
(a) Year
(b) Month
(0. 6)
*Oct.---
X
Y
Z
Nov.---
Dec.---
4
5
3
(c) Date
1-9---
0
1
2
10-19---
20-31---
2
1
(2) Part Number Mark
(1. 80)
6
Pin no.
Connection
GND
1
2
3
4
5
6
(0. 75)
[4x]
(0. 45)
IN
GND
Fig.2 Package dimensions (in mm)
3.8
GND
OUT｜
GND
2.2
1.15
1.15
Fig.3 Desirable land area (in mm)
NSVS1196 Apr. 2013
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -40ºC or more than +85ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 10 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influences for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
2. The information contained herein may be changed without prior notice. It is
therefore advisable to contact New Japan Radio Company before proceeding
with the design of equipment incorporating this product.
3. The products are designed to be used with ordinary electronic equipment (data
and communications equipment, office equipment, audio-video equipment,
measuring instruments, etc). New Japan Radio Company does not assume any
liability for the case using the products with the application required high
reliability or safety extremely (such as space equipment, sea-bottom equipment,
medical equipment etc). When intending to use any our product please contact
our sales representatives in advance.
NSVS1196 Apr. 2013
FREQUENCY CHARACTERISTICS
S21
0
0
6
2
12
18
24
30
4
6
8
10
CH1 : center 433.92 span 1
CH2 : center 433.92 span 1
S11
S22
S11
S22
11
11
9
9
7
5
3
1
7
5
3
1
433.4
433.9
434.4
433.4
433.9
434.4
Frequency [MHz]
Frequency [MHz]
相关型号：
©2020 ICPDF网 联系我们和版权申明