P14RG-2405E41LF [PEAK]
PMBW-SERIES;型号: | P14RG-2405E41LF |
厂家: | PEAK ELECTRONICS GMBH |
描述: | PMBW-SERIES |
文件: | 总4页 (文件大小:154K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
P14RG-xxxxE/Z4:1LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PMBW-SERIES
ꢀ 3 Watt
ꢀ 4:1 Ultra Wide Input
ꢀ Reg. Single and Dual Output
ꢀ 1.5 kV DC I/O Isolation
ꢀ SIP9 case
Rev.04-2009
The PMBW 3Watt series is a family of cost effective DCDC converters with
4:1 ultra wide input, 3W single and dual output DC/DC converters with
control Pin. These converters are encapsulated in an ultra miniature SIP9
plastic case. High performance features: continuous / long time short circuit
protection with automatic restart and tight line / load regulation, high
efficiency operation and output voltage accuracy of ±2% maximum.
ꢀ On/Off Control
ꢀ Contin. Short Circuit Protection
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
Start-up Time
4:1 Ultra Wide Input (see table)
Capacitor
20 mA pk-pk
10 mS, typ.
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
1%
Indefinite (hiccup, Automatic Recovery)
0.5%
Load Regulation (0% - 100%)
Cross Regulation (Dual Output)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
Transient Recovery Time3
Transient Response Deviation3
0.5%, max.(<10% load: 1% for 3.3Vout and 5Vout)
5%
50 mV pk-pk
0.02% / °C
300 us, typ.
3%, max.
General Specifications
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
1500 VDC
500 pF, max.
1000 M Ohm
250 kHz
95% rel H
> 1.212 Mhrs
Reliability Calculated MTBF (MIL-HDBK-217F)
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 6.5 g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
-40 to +75°C (ambient)
100°C
-40 to +125°C
Free Air Convection (10mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
RoHS Conform
PMBW-Series – P14RG-xxxxE/Z4:1LF – Single / Dual Output – SIP9 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4
Selection Guide
Single/Dual Output
Order #
SINGLE OUTPUT
P14RG-243R3E4:1LF
P14RG-2405E4:1LF
P14RG-2412E4:1LF
P14RG-2415E4:1LF
P14RG-483R3E4:1LF
P14RG-4805E4:1LF
P14RG-4812E4:1LF
P14RG-4815E4:1LF
9-36
9-36
10
10
10
10
5
125
153
149
148
65
3.3
5
0
0
0
0
0
0
0
0
700
600
250
200
700
600
250
200
77
82
84
85
75
81
84
84
2200
1000
165
9-36
12
15
3.3
5
9-36
100
18-72
18-72
18-72
18-72
2200
1000
165
5
78
5
75
12
15
5
75
100
Order #
DUAL OUTPUT
P14RG-2405Z4:1LF
P14RG-2412Z4:1LF
P14RG-2415Z4:1LF
P14RG-4805Z4:1LF
P14RG-4812Z4:1LF
P14RG-4815Z4:1LF
9-36
9-36
10
10
10
5
155
149
149
78
5
0
0
0
0
0
0
300
125
100
300
125
100
81
84
84
81
84
83
470
100
47
12
15
5
9-36
18-72
18-72
18-72
470
100
47
5
75
12
15
5
76
If you need other specifications, please enquire.
PMBW-Series – P14RG-xxxxE/Z4:1LF – Single / Dual Output – SIP9 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 2/4
Package / Pinning / Derating
PIN CONNECTIONS
SINGLE DUAL
#
1 - Vin
- Vin
+Vin
2 +Vin
3 Ctrl.
Ctrl.
6 +Vout
7 N.C.
8 N.C.
9 - Vout
+Vout
Common
N.C.
- Vout
App Notes:
1 = Measured Input reflected ripple current with a simulated source inductance of 12uH
2 = Tested by nominal Vin and constant resistive load.
3 = Test by normal Vin and 100%-25% load,25% Ioad step change; If Vout is 3.3V then the Transient Response Deviation is ±5%.
4 = Input filter components are required to help meet conducted emission class A
5 = An external filter capacitor is required to meet EN61000-4-4 and EN61000-4-5. (e.g. Nippon-chemi-con KY series, 220uF/100V)
EMC SPECIFICATIONS
Remote ON/OFF
Conducted
EN 55022
CLASS A
Emissions4
Radiated
Emissions
ESD
The MCU Pin Voltage is referenced to –Vin (Pin1)
ON: 0 – 0.6 VDC or open circuit
OFF: 2.7 - 15 VDC
EN 55022
CLASS A
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
Perf. Criteria B
Perf. Criteria A
Perf. Criteria B
Perf. Criteria B
Perf. Criteria A
Perf. Criteria A
OFF stand by input current: 5mA, max.
RS
EFT5
Surge5
CS
PFMF
PMBW-Series – P14RG-xxxxE/Z4:1LF – Single / Dual Output – SIP9 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 3/4
App Notes
Test Configurations
Input Reflected Ripple Current
Test Step
Input reflected ripple current is measured
through a source inductor Lin(12uH) and a
source capacitor Cin(47uF, ESR<1.Ohm at
100KHz) at nominal input and full load.
Output Ripple & Noise
Measurement Test
The Scope measurement bandwidth is
20MHz.
EMI Filter
Input filter components (C1, L) are used to
help meet conducted emissions
equirement for the module. These
components should be mounted as close
as possible to the module; and all leads
should be minimized to decrease radiated
noise.
Input Components
C1
L
P14RG-24xx
P14RG-48xx
1210, 225k/100V,X7R (2pcs)
1210,105k/100V,X7R
6.8 uH
56 uH
PMBW-Series – P14RG-xxxxE/Z4:1LF – Single / Dual Output – SIP9 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 4/4
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明