PLC-040S222D [QUALTEK]
40Watts Single Output LED Driver; 40Watts单路输出LED驱动器型号: | PLC-040S222D |
厂家: | QUALTEK ELECTRONICS CORPORATION |
描述: | 40Watts Single Output LED Driver |
文件: | 总3页 (文件大小:1618K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
P
ualtek
Q
P C
40Watts Single Output LED Driver
PLC-040 D Series
Electronics Corporation
Features:
Constant Current Design
Dimming Control
Universal AC input/ Full Range
Built-in Active PFC function, PF 0.95 Typical
High Efficiency (Up to 88%)
Output Protections: OVP/SCP/OTP
Lightning Protection
Class 2 Power Unit (See Note)
Waterproof (IP65)
3 Year Warranty
PLC-040S035D PLC-040S045D PLC-040S070D PLC-040S105D PLC-040S128D PLC-040S140D`PLC-040S166D PLC-040S222D PLC-040S333D
Model
Output Characteristics
0.35A (1)
38~114V
±10% Vo
±5% Vo
±1% Vo
±5% Vo
0.45A (1)
30~89V
0.70A (2)
18~54V
1.05A (3)
12~36V
1.28A (3)
10~29V
1.40A (3)
10~25V
1.66A (3)
8~23V
2.22A (3)
6~16V
3.33A (3)
4~11V
Rated Current
Voltage Range
See Note
Ripple and Noise (max) Note 1
Voltage Accuracy
Line Regulation
Load Regulation
20mS Max @ Rated Load
Rise Time
8.5mS Min (110VAC input, full load), 10mS Min (220VAC input, full load)
Hold-up Time (Typ.)
Input Characteristics
Voltage Range
90VAC~305VAC
47Hz-63Hz
Frequency Range
>0.95
>0.90
88%
>0.95
>0.90
88%
>0.95
>0.90
87%
>0.95
>0.90
87%
>0.95
>0.90
87%
>0.95
>0.90
87%
>0.95
>0.90
86%
>0.95
>0.90
85%
>0.95
>0.90
84%
Power Factor
(Typical)
110VAC
220VAC
Efficiency (Typical)
AC Current (max)
Inrush Current (max)
Leakage Current
0.6A @ 100-277VAC Input Full Load
65A @ 230VAC, 25°C
0.5mA max @ 277VAC
Protection
110°C (Temperature of internal components); shut down, auto recover after the temperature decreases
Over Temperature (OTP)
1.2~1.7Vo
Over Voltage (OVP)
Short Circuit (SCP)
Note 2
Long-term mode, auto recovery
Environmental Characteristics
Operating Temperature
Operating Relative Humidity
Storage Temperature
Vibration
-35°C~70°C
5% RH to 95% RH
-40°C~85°C, 5% to 100% RH non-condensing
10 to 300Hz sweep at constant acceleration of 1.0G(Breadth: 3.5mm) for 1 Hour for each of the perpendicular axes X, Y, Z
IP65
Waterproof Rating
Safety Standards
Withstand Voltage
Isolation Resistance
EMC Emission
UL8750, Compliance to UL1012 UL935, IEC61347
L/N-GND: 4kV, L-N: 2kV
I/P-O/P: >100M Ohms / 500VDC / 25°C / 70% RH
Compliance to EN55022(CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-3-2, 3 EN61000-4-2, 3, 4, 5, 6, 8, 11, EN61547
EMC Immunity
Characteristics
Life Time
More than 78,000Hrs (25°C, 80% Load)
MTBF (MIL-HDBK-217F)
Dimension (LxWxH)
Note
More than 492,000Hrs (25°C, 80% Load)
95x70x32mm
1. Ripple & Noise: Measured by 20 MHz bandwidth oscilloscope and the output paralleled with a 0.1 uF ceramic capacitor and a 10 uF electrolytic capacitor.
2. Latch Mode: The power supply shall return to normal operation only after the power is turned on again
(1) Non-Class 2 output (USR & CNR)
(2) Class 2 output (USR); Non-Class 2 output (CNR)
(3) Class 2 output (USR & CNR)
Page 1 of 3
P
ualtek
Q
P C
40Watts Single Output LED Driver
PLC-040 D Series
Electronics Corporation
DIMMING CONTROL
The dimmer control may be operated from either a potentiometer or from an input
signal of 1 – 10 Vdc. Two recommended implementations are provided below.
1-10V
INPUT (PURPLE)
10V OUTPUT
(YELLOW)
1-10V
INPUT(PURPLE)
1-10Vdc
20K
PLC-040SXXXD
PLC-040SXXXD
V
GND(GREEN)
GND(GREEN)
Implementation 1: DC Input
Implementation 2: Potentiometer Control
Io/Ir Vs Vdim
100%
80%
60%
40%
20%
0%
0
1
2
3
4
5
6
7
8
9
10 11
Vdim(V)
Notes:
1. Io is actual output current and Ir is rated current.
2. If the dimming function is not used, please short 10 V output pin (yellow) and 1-10 V input pin(purple).
The output current is about 92% Ir when the 1-10V input pin is ꢀoating.
3. For the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold
(approx. 50% of the max. output voltage for any given model).
4. The dimming voltage can be tuned down to less than 1V, and the output current will be decreased to about
10% Ir; but the connected LEDs may ꢀicker. Keeping dimming voltage greater than 1V is strongly recommended.
5. Do not connect the GND of dimming to the output; otherwise, the LED driver will not work normally.
www.qualtekusa.com
ISO-9001 Company
Page 2 of 3
P
ualtek
Q
P C
40Watts Single Output LED Driver
PLC-040 D Series
Electronics Corporation
UNIT: mm
MECHANICAL SPECIFICATIONS
Derating Curve
Ambient Temperature vs.Load
100
80
60
40
20
0
100
80
60
40
20
0
90
120
150
180
210
240
270
300
330
-35
-20
-5
10
25
40
55
70
Ambient Temperature(°C)
Input Voltage(V)
www.qualtekusa.com
Rev. B
ISO-9001 Company
Page 3 of 3
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明