BA6208F-E2 [ROHM]
BRUSH DC MOTOR CONTROLLER, 0.5A, PDSO8, SOP-8;
| 型号： | BA6208F-E2 |
| 厂家： | 
ROHM |
| 描述： | BRUSH DC MOTOR CONTROLLER, 0.5A, PDSO8, SOP-8 电动机控制 光电二极管 |
| 文件： | 总3页 (文件大小：49K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Motor driver ICs
Reversible motor driver
BA6208 / BA6208F
The BA6208 and BA6208F are monolithic ICs used for driving reversible motors. They allow control of reversible motors
in cassette players and other electrical equipment by using TTL-level logic signals.
The ICs contain a logic section, which controls forward and reverse rotations as well as forced stop, and an output power
section, which can supply an output current of up to 100mA (typical) according to the logic control.
FFeatures
1) Motor driving power transistors are built in (100mA
typically).
4) Very low standby circuit current when inputs A and B
are both LOW level.
2) Brake is applied when stopping the motor (when in-
puts A and B are both HIGH level).
5) Wide range of operating supply voltage (4.5 X
15.0V).
3) Built-in diode to absorb surge currents.
6) Direct control with the TTL logic.
FAbsolute maximum ratings (Ta = 25_C)
FRecommended operating conditions (Ta = 25_C)
FInput truth table
384
Motor driver ICs
BA6208 / BA6208F
FElectrical characteristics (unless otherwise noted, Ta = 25_C and VCC = 9V)
FInternal circuit configuration
FExternal dimensions (Units: mm)
385
Appendix
Notes
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document use silicon as a basic material.
Products listed in this document are no antiradiation design.
The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level of
reliability and the malfunction of with would directly endanger human life (such as medical instruments,
transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other
safety devices), please be sure to consult with our sales representative in advance.
About Export Control Order in Japan
Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control
Order in Japan.
In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)
on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.
Appendix1-Rev1.0
相关型号：
©2020 ICPDF网 联系我们和版权申明