SW1AB-350 [SHINMEI]
Lever-type Detector Switches;型号: | SW1AB-350 |
厂家: | SHINMEI |
描述: | Lever-type Detector Switches |
文件: | 总3页 (文件大小:125K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
http://www. shinmei-e. co. jp
Lever-type Detector Switches
SW1AB-350 Series
1/3
[] Features
<>Miniaturized for space saving design.
<>Superior reliability at micro-current by employing a sliding contact.
<>This is a compact detector switch which can be pressed either horizontally or vertically.
<>Reflow soldering is possible.
[] Applications
<>Mechatronic detection for audio and VCR Digital camera FDD units.
[] Products Number System
SW 1 AB - [ ][ ][ ] - [ ][ ]
Difference version , etc.
Series
Actual size
Zoom
Contact arrangement
Pole
Detector switch
[] Products Line
Quantity
(pcs./reel)
No
Products No
Pole
Position
Notes
1
2
SW1AB-350-T17
SW1AB-350-1T15
1
1
1
1
1,700
1,500
3 operating direction is possible.
2 operating direction is possible.
[] Typical Specifications
Item
Specification
Ratings (max.)
0.1 to 5mA 5V DC (Resistive load)
1 ohm max.
Contact resistance
Insulation resistance
Withstanding voltage
Operating life with load
100 megohm min. 100V DC
100V AC for 1min.
50,000 cycles
Operating force
0.323N max.
SHINMEI ELECTRIC CO., LTD.
SW1AB-350 Series
2/3
[] Dimensions
No
Unit : mm
P.C.B reference Land Dimensions
Circuit diagram
Style
(TOP VIEW)
SW1AB-350-T17
1
SW1AB-350-1T15
2
SHINMEI ELECTRIC CO., LTD.
SW1AB-350 Series
3/3
[] Notes
1.
2.
3.
4.
5.
6.
The appearance and specifications of the product may be modified to improve its performance without prior notice.
This catalog shows only outline specifications. When using the product, please obtain formal specifications.
Please see appendix [Cautions in Using Switches ].
This switch is not washable.
Soldering shall be done with actuator at free position and take care not to attach flux on plastic portion.
Note that if the stress is applied to the terminals during soldering, they might cause deformation and defects in
electrical performance.
7.
8.
In manual soldering, consideration should be given to apply the soldering iron to the tip of the terminal so that
unusual pressure is not applied to the terminal.
In case circuit and software design consideration against chattering and bouncing shall be taken as below.
Read a few times. (Ex. 5ms for 5 times)
Set delay time.
Set integral circuit.
9.
As to threshold voltage, center setting is recommended.
10. Care shall be taken not to apply stress to the body of switch as it may affect the performance.
11. Please confirm the performance on actual operation by simulation with actual environment environments for high
reliability.
SHINMEI ELECTRIC CO., LTD.
相关型号:
©2020 ICPDF网 联系我们和版权申明