CENB1020 [SLPOWER]
ITE Switch-Mode Power Supply; ITE开关模式电源
| 型号： | CENB1020 |
| 厂家： | 
SL Power Electronics |
| 描述： | ITE Switch-Mode Power Supply |
| 文件： | 总2页 (文件大小：411K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
CENB1020
Universal 20 Watt Series
ITE Switch-Mode Power Supply
3 Year Warranty
•100-240VAC Universal Input Range
•Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
•
•
•
•
•
•
•
•
Desktop & Wall Plug Styles
5V to 48V Single Output Models, up to 19W
Modified and Custom Designs Available
Regulated Output with Low Ripple
Impact-Resistant Polycarbonate Enclosure
No load Power Consumption <0.3W
Limited Power Source
nd
RoHS
LPS
Specifications
All Specifications are typical at nominal input, full load at 25
MTBF
100Vac: 0.45A Hold-up Time
°
C unless otherwise stated.
100,000 hours (calculated)
AC Input
100-240Vac, -/-10%, 47-63 Hz, 1∅
Input Current
Inrush Current
18 ms min. @ 115Vac, 60 ms min. @ 230 Vac
Hiccup Mode
Inrush limiting provided, 60 A peak
Overload Protection
Short Circuit Protection
Topology
Input Fuse
Efficiency
Internal Primary Current Fuse provided: 3.15A, 250Vac
Hiccup Mode
Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
Switching – Fixed Frequency Flyback
Output Voltage
Output Power
See chart
Safety Standards
EN/IEC/CSA/UL60950-1, 2nd Edition, LPS
See chart
EMC, Radiated & Conducted
Dielectric Withstand
See chart below
Ripple and Noise
1% pk-pk max., 20MHz BW
Input-Output: 4,242VDC,
Input-Ground: 1,500Vac, Output-Ground: 500Vdc
0° to 40°C, no derating
-30 to +85°C
Line & Load Voltage Regulation
Minimum Load
Line: +/- 1%, Load: +/-5%
Not required
Operating Temperature
Storage Temperature
Relative Humidity
Altitude
Transient Response
Case Dimensions
Case Material
500 us max, 50% load step
84 X 47 X 32mm. See outline drawing
5% to 95%, non-condensing
0 to 10,000 ft
Black 94V0 Polycarbonate Turn-on Time
150g Output Cable
2 sec max, 115/230 Vac
Weight
5V – 9V outputs: #18AWG (SPT-1), 1500mm, 2 conductor
12V – 48V outputs: #20AWG (UL1185), 1500mm, 2 conductor
Output Connector
2.5mm barrel type (Ault #3), center contact (+)
EMC Specifications
Conducted Emissions
EN55022 Class B, FCC Part 15, Class B.
Radiated Emissions
EN55022 Class B, FCC Part 15, Class B.
EN61000-3-2, Class A
Line Frequency Harmonics
Voltage Fluctuations/Flicker
Static Discharge Immunity
Radiated RF Immunity
EN61000-3-3
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz.
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
EN61000-4-6, 3Vrms
Conducted RF Immunity
Power Frequency Magnetic Field Immunity
Voltage Dip Immunity
EN61000-4-8, 3A/m
EN61000-4-11, Criteria B
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com
CENB1020
Universal 20 Watt Series
ITESwitchModePowerSupply
3YearWarranty
Model Number
Volts (V)
Output Current (max)
Max Watts
Ripple (Vp-p max)
CENB1020A0303F01
CENB1020A0503F01
CENB1020A0603F01
CENB1020A0703F01
CENB1020A0903F01
CENB1020A1203F01
CENB1020A1403F01
CENB1020A1503F01
CENB1020A1803F01
CENB1020A2403F01
CENB1020A4803F01
3.3 V
5 V
6 V
7.5 V
9 V
12 V
14 V
15 V
18 V
24 V
48 V
3.00 A
3.00 A
2.50 A
2.00 A
2.00 A
1.50 A
1.20 A
1.20 A
1.00 A
0.75 A
0.40 A
9.9 W
15.0 W
15.0 W
15.0 W
18.0 W
18.0 W
16.8 W
18.0 W
18.0 W
18.0 W
19.2 W
50 mV
50 mV
60 mV
75 mV
90mV
120mV
140mV
150mV
180mV
240mV
480mV
Notes: Part numbers above include #3 output connector and IEC320 C14 grounded input receptacle. See below for other options.
Model Number Key
CENB 1 020 A VV 03 F 01
Model
"01" = Standard. "02" and higher indicates a modified model.
"F" = IEC320 C14 grounded, Other options available, see below
Input Connector:
Output Connector: "03" = 2.5mm Barrel Type Connector. Other options available, contact factory.
Output Voltage:
Model
"05" = 5Vdc, "12" = 12Vdc, "24" = 24Vdc, etc.
"A" = Original Configuration
Output Power:
# of Outputs
Product Family:
"020" = 20 Watts
"1" = Single Output
"C" = Commercial/ITE/Industrial, "E" = External, "NB" = Model Series Designator
AC Input Receptacle Options
Output Connector
Desktop
Wall-Plug
IEC320 - C14
Class I
Grounded
(F)
IEC320 - C18
Class II
IEC320 - C8
Class II
"Shaver"
(N)
N. America N. America
Europe
United
Kingdom
Fixed
Australia
Japan
Interchangable
(B)
Japan
Fixed
(C)
Ungrounded
(Q)
Fixed
(M)
Fixed
(H)
(G)
Notes:
1. For desktop options, choose applicable letter above.
Notes:
1. Ault #3 Connector, center contact (+).
2. For Wall-Plug options, choose the applicable letter above and the unit will be fitted with
the receptacle chosen. The N. A. blade version (B) will be an interchangeable blade.
The other options (C), (M), (G), and (H) will be fixed blades molded in the case.
3. Blade Kit is available which will include one each of a EU, UK, and Australian blade. Kit part #
is KT1027K. These can be used with the (B) version, to allow blades to be changed.
2. Connector is Switchcraft 760 plug or equivalent.
Mating connector is Switchcraft 712A or equivalent.
3. Other connector options are available. Contact your local
SL Power Representative for details.
Outline Drawing
DATE
CODE
DATE
CODE
Desktop Style
Wall-plug Style (Option “B” shown)
Data Sheet © 2010 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
Rev. 12-22-2010
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com
相关型号：
©2020 ICPDF网 联系我们和版权申明