GLM75-12 [SLPOWER]

Power Supply Module;


型号：	GLM75-12
厂家：	SL Power Electronics
描述：	Power Supply Module 输出元件
文件：	总2页 (文件大小：201K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

GLC75 Commercial/GLM75 Medical

75 Watt Single Output Global Performance Switchers

FEATURES:

• Cost-effective single-output power source

• 3.4" x 5.75" x 1.56" (meets 1U applications)

• Universal input 90-264 Vac

• 2-year warranty

• Complies with EN61000-3-2 Class A

• Also available in multiple output versions

• Conducted EMI exceeds FCC Class B and CISPR 22

Class B (Commercial models) and CISPR 11 Class B

(Medical models)

• Commercial Approved to UL1950, CSA22.2 No. 234

and IEC950, EN60950

• Medical Approved to UL2601-1, IEC601-1 and

CSA22.2 No. 601

SPECIFICATIONS:

Ac Input

•

marked to LVD

90-264 Vac, 47-63 Hz single phase.

Inrush Current

Input Current

Maximum input current at 120 Vac, 60 Hz with full rated

output load not to exceed 2.3 A.

Inrush limited by internal thermistors. Inrush at 240 Vac,

averaged over the first ac half-cycle under cold start

conditions will not exceed 37 A.

Output Power

Normal continuous output power is 75 W for unrestricted

natural convection cooling; 110 W with 26 cfm airflow.

Temperature Coefficient

0.03%/°C typical on all outputs.

Power Fail

Output Regulation

A standard TTL or CMOS compatible output goes low

(< 0.5 V) 5ms before output voltage drops more than 4%

below nominal voltage upon loss of ac power. Signal is

factory set to trip on 84 to 94 Vac brown-out depending

upon incoming line impedance and distortion. Other

settings are available through adjustment of built-in

potentiometer (consult factory for assistance). Output will

stay low for 20 ms minimum.

Regulation measured by changing from 5% to 50% load

or 50% load to full load in either direction.

Overload Protection

Factory set to begin power limiting at approximately 120

W (GLC 75-5 is set at approximately 100 W). Fully

protected against short circuit and output overload. Short

circuit protection is cycling type power limit.

EMI/EMC Compliance

Output Noise

All models include built-in EMI filtering to meet the

following emissions requirements:

EMI SPECIFICATIONS

Conducted Emissions GLC75 EN55022 Class B; FCC Class B

Conducted Emissions GLM75 EN55011 Class B; FCC Class B

0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential

mode. Measured with noise probe directly across output

terminals of the power supply.

COMPLIANCE LEVEL

Transient Response

Static Discharge

EN61000-4-2, 6 kV contact, 8 kV air

EN61000-4-3, 3 V/meter

EN61000-4-4, 2 kV, 5 kHz

EN61000-4-5, 1 kV diff., 2 kV com.

EN61000-3-2 Class A

Main Output: 500 µs typical response time for return to

within 0.5% of final value for a 50% load step change, ∆i/

∆t<0.2 A/µs. Maximum voltage deviation is 3.5%. Startup/

shutdown overshoot less than 3%.

RF Field Susceptibility

Fast Transients/Bursts

Surge Susceptibility

Line Frequency Harmonics

Overvoltage Protection

Standard on all models.

Commercial Safety

All GLC models are approved to UL1950, CSA22.2 No.

234 Level 3, IEC950 and EN60950. Consult factory for

approval status.

Voltage Adjust

Factory set on standard unit; however, potentiometer

adjusts voltage ±5% minimum. Consult factory for

application assistance.

Medical Leakage Current

70 µA 264 V @ 50 Hz (normal conditions).

Efficiency

72-85% depending on model.

Medical Safety

All GLM models are approved to UL2601-1, CSA-C22.2

No. 601.1, IEC601-1 and EN60601-1. Consult factory for

approval status.

Input Protection

Internal ac fuse provided. Designed to blow only if a

catastrophic failure occurs in the unit—fuse does not blow

on overload or short circuit.

Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033

800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com

GLC75 Commercial/GLM75 Medical 75 Watt Single Output

Commercial

Model

Medical

Model

Output

Minimum

Output Maximum Output Maximum

Output

Peak

Total

Regulation

Output

(A)

(B)

V1 OVP Set

6.2 ± 0.6 V

Noise P-P

50 mV

GLC75-5

GLM75-5

5.1 V

12 V

15 V

24 V

28 V

0 A

13.7 A

19.6 A

21 A

9.5 A

7.7 A

5 A

GLC75-12

GLC75-15

GLC75-24

GLC75-28

GLM75-12

GLM75-15

GLM75-24

GLM75-28

6.3 A

5 A

9.1 A

7.3 A

4.6 A

4 A

15.6 ± 1.1 V

18.5 ± 1.5 V

28 ± 2.5 V

34 ± 2.8 V

120 mV

150 mV

240 mV

280 mV

3.1 A

2.7 A

4.4 A

A. Rating with unrestricted convection cooling. Total power not to exceed 75 W.

B. Rating with 26 cfm forced-air cooling. Total power not to exceed 110 W.

GLC75/GLM75 MECHANICAL SPECIFICATIONS

Environmental

Specification

Operating

Non-operating

Temperature (A)

0 to 50^oC

0 to 95% RH

20 g_pk

-40 to +85^oC

0 to 95% RH

40 g_pk

Humidity (A)

Shock (B)

Altitude

A. Units should be allowed to warm up/operate under non-condensing conditions

before application of power.

B. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3

orthogonal axes.Tested for 10 min./axis operating and 1 hr./axis non-operating.

C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal axes,

total 6 shocks.

-500 to 10,000 ft

1.5 g_rms, 0.003 g²/Hz

-500 to 40,000 ft

5 g_rms, 0.026 g²/Hz

Vibration (C)

Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033

800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com

相关型号：