GPM40BG [SLPOWER]

AC-DC Regulated Power Supply Module, 40W;
GPM40BG
型号: GPM40BG
厂家: SL Power Electronics    SL Power Electronics
描述:

AC-DC Regulated Power Supply Module, 40W

输出元件
文件: 总2页 (文件大小:241K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
GPC40 Commercial/GPM40 Medical  
40 WATT GLOBAL PERFORMANCE SWITCHERS  
GLOBAL PERFORMANCE SWITCHERS  
Summary:  
• Wide-range ac input 85-264 Vac  
• 2-year warranty  
D C P o w e r S u p p l i e s  
• Conducted EMI exceeds FCC Class B and CISPR 22  
Class B (Commercial models) and CISPR 11  
Class B (Medical models)  
• Single and multiple outputs  
• Commercial Approved to UL1950,  
EN60950 E3:2000 and CSA-C22.2 No. 234  
• Medical Approved to UL2601-1, EN60601-1 and  
CSA22.2 No. 601  
• Single and multiple outputs  
• RoHS compliant models available (G suffix)  
marked to LVD  
SPECIFICATIONS  
Ac Input  
Output Noise  
85-264 Vac, 47-63 Hz single phase.  
0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential mode. Measured with noise  
probe directly across output terminals of the power supply.  
Input Current  
Transient Response  
Maximum input current at 120 Vac, 60 Hz with full rated output load: 1.3 A  
Main output—500 μs typical response time for return to within 0.5% of final value  
for a 50% load step change. ∆i/ ∆t<0.2 A/μs. Maximum voltage deviation is 3.5%.  
Startup/ shutdown overshoot less than 3%.  
Hold-Up Time  
20 ms minimum from loss of ac input at full load, nominal line (115 Vac).  
Output Power  
Remote Sense  
Provided as a standard feature on single-output models.  
40 W continuous, 50 W peak. Peak ratings are for 60 s maximum duration,  
10% duty cycle. During peak load condition, output regulation may exceed  
total regulation limits.  
Voltage Adjustment  
Built-in potentiometer adjusts main output voltage 5%.  
Overload Protection  
EMI/EMC Compliance  
All models include built-in EMI filtering to meet the  
following emissions requirements:  
Fully protected against short circuit and output overload.  
Short circuit protection is cycling type power limit on outputs 1 & 2; foldback  
type on output 3. Recovery after fault is automatic. See output ratings chart  
for additional notes or conditions.  
EMI SPECIFICATIONS  
COMPLIANCE LEVEL  
Overvoltage Protection.  
Main outputs: 124% 12%.  
Conducted Emissions  
Conducted Emissions  
Static Discharge  
RF Field Susceptibility  
Fast Transients/Bursts  
Surge Susceptibility  
Line Frequency Harmonics  
EN55022 Class B; FCC Class B  
EN55011 Class B; FCC Class B  
EN61000-4-2, 6 kV contact, 8 kV air  
EN61000-4-3, 3 V/meter  
EN61000-4-4, 2 kV, 5 kH  
EN61000-4-5, 1 kV diff., 2 kV com.  
EN61000-3-2  
Efficiency  
70% at full rated load, nominal input voltage, depending on model and load  
distribution.  
Turn-on Time  
Less than 1 second at 120 Vac, 25°C (inversely proportional to input voltage  
and thermistor temperature).  
Commercial Safety  
Approved to UL1950, CSA22.2 No. 950, IEC950, EN60950. All dc outputs are SELV  
under normal and single fault conditions.  
Input Protection  
Internal ac fuse provided. Designed to blow only if a catastrophic failure oc-  
curs in the unit.  
Medical Leakage Current  
The maximum leakage current is as follows:  
Test Condition  
120 Vac @ 60 Hz input  
264 Vac @ 60 Hz input  
Inrush Current  
Inrush is limited by internal thermistors. Inrush at 240 Vac under cold start  
conditions will not exceed 34 A.  
Normal Single  
25 μA  
40 μA  
Fault  
35 μA  
60 μA  
Temperature Coefficient  
0.03%/°C typical on all outputs.  
Medical Safety  
Approved to UL2601-1, CSA22.2 No. 601 Level 3 and EN60601-1. UL file E116994;  
CSA #LR46516. The output(s) are intended for safety earthed Signal Output  
and Intermediate Circuits only. The output(s) are not acceptable for patient con-  
nection without additional isolation. All dc outputs are SELV under normal and  
single fault conditions.  
Environmental  
Designed for 0 to 50°C operation at full rated output power; derate output  
current and total output power by 2.5% per °C above 50°C.  
All specifications are typical at nominal input, full load at 25OC unless otherwise stated  
Commercial  
Model  
Medical  
Model  
Output No.  
Output  
Output  
Minimum  
Output  
Maximum  
Output  
Peak  
Noise P-P  
Total  
Regulation  
Notes  
GPC40A  
GPC40B  
GPC40D  
GPM40A  
GPM40B  
GPM40D  
1
2
3
1
2
3
1
2
3
1
1
1
1
1
1
1
+5.1 V  
+12 V  
-12 V  
+5.1 V  
+15 V  
-15 V  
+5.1 V  
+24 V  
-12 V  
3.3 V  
5 V  
0.4 A  
0 A  
0 A  
0.4 A  
0 A  
0 A  
0.4 A  
0.A  
0.A  
0
4 A  
2 A  
5 A  
3 A  
50 mV  
120 mV  
120 mV  
50 mV  
2%  
5%  
3%  
2%  
5%  
3%  
2%  
5%  
3%  
2%  
2%  
2%  
2%  
2%  
2%  
2%  
B,C  
C
0.4 A  
4 A  
0.7 A  
5 A  
2 A  
3 A  
150 mV  
150 mV  
50 mV  
B,C  
C
0.4 A  
4 A  
0.7 A  
5 A  
1 A  
1.5 A  
0.7 A  
10 A  
10 A  
6 A  
240 mV  
120 mV  
35 mV  
B,C  
C
0.4 A  
8 A  
GPC40-3.3  
GPC40-5  
GPM40-3.3  
GPM40-5  
0
8 A  
50 mV  
GPC40-9  
GPM40-9  
9 V  
0 A  
0 A  
0 A  
0 A  
0 A  
4.5 A  
3.3 A  
2.7 A  
1.7 A  
1.4 A  
90mV  
GPC40-12  
GPC40-15  
GPC40-24  
GPC40-28  
GPM40-12  
GPM40-15  
GPM40-24  
GPM40-28  
12 V  
4.2 A  
3.3 A  
2.1 A  
1.8 A  
120 mV  
150 mV  
240 mV  
280 mV  
15 V  
24 V  
28 V  
Note: For 48 volt model, GPC40-48 or GPM40-48, contact factory for availability.  
A. Total regulation is defined as the maximum deviation from the nominal voltage for all steady-state conditions of initial voltage setting, input line voltage and output load.  
B. To maintain these regulation conditions, the 5.1V current must be at least 1/4 of V2 and not greater than 5 times the V2 current.  
C. Requires +5.1V to be adjusted within 1% with at least a 0.4A load to maintain regulation on this output.  
D. Add “Gsuffix to model number for RoHS compliant model.  
GPC40/GPM40 MECHANICAL SPECIFICATIONS  
3
3
A. Units should be allowed to warm up/operate under non-condensing  
ENVIRONMENTAL SPECIFICA-  
OPERATING  
NON-OPERATING  
onditions before application of power.  
B. Shock testing—half-sinusoidal, 10 3 ms duration, direction,  
3 orthogonal axes, total 6 shocks.  
C. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to  
2000Hz, 3 orthogonal axes. Tested for 10 min./axis operating and  
1 hr./axis non-operating.  
TIONS  
Temperature (A)  
Humidity (A)  
Shock (B)  
See individual specs. -40 to +85°C  
0 to 95% RH  
0 to 95% RH  
40 gpk  
20 gpk  
Altitude  
-500 to 10,000 ft  
1.5 g rms0.003 g2/Hz  
-500 to 40,000 ft  
5 g rms0.026 g2/Hz  
Vibration (C)  
SL Power Electronics Corp, 6050 King Drive, Bldg. A, Ventura, CA 93003, USA. Phone:(805) 486 4565 Fax:(805) 487 8911 www.slpower.com. Rev. 1/07.  
Data Sheet © 2007 SL Power Electronics Corp. The information and specifications contained in this data sheet are believed to be correct at time of publication.  
However, Condor accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.  

相关型号:

SI9130DB

5- and 3.3-V Step-Down Synchronous Converters

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135LG-T1-E3

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9135_11

SMBus Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9136_11

Multi-Output Power-Supply Controller

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130CG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130LG-T1-E3

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9130_11

Pin-Programmable Dual Controller - Portable PCs

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137DB

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9137LG

Multi-Output, Sequence Selectable Power-Supply Controller for Mobile Applications

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY

SI9122E

500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification Drivers

Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY