STEVAL-IHM021V2 [STMICROELECTRONICS]
100 W, 3-phase inverter based on the L6390 and UltraFASTmesh⢠MOSFET for speed FOC of 3-phase PMSM motor drives; 100瓦的基础上， L6390和UltraFASTmeshâ ?? ¢的MOSFET为3相永磁同步电动机驱动速度的FOC 3相逆变器
| 型号： | STEVAL-IHM021V2 |
| 厂家： | 
ST |
| 描述： | 100 W, 3-phase inverter based on the L6390 and UltraFASTmesh⢠MOSFET for speed FOC of 3-phase PMSM motor drives |
| 文件： | 总5页 (文件大小：176K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
STEVAL-IHM021V2
100 W, 3-phase inverter based on the L6390 and UltraFASTmesh™
MOSFET for speed FOC of 3-phase PMSM motor drives
Data brief
Features
■ Wide range input voltage
■ Maximum power: up to 100 W at 230 Vac input
■ STD5N52U power MOSFET (4.4 A, 520 V)
■ Compatible with other power switches in DPAK
packages (i.e. the STGD6NC60HD or
STGDL6NC60DI)
■ 15 V auxiliary power supply connector
■ Motor control connector for interfacing with
STM32-based control stages
■ Three shunt resistor-based motor current
sensing network
STEVAL-IHM021V2
■ Target applications: refrigerator compressors
frequencies lower and higher than 10 kHz,
respectively. In either case, no replacement of the
switches driving the network is required.
and dishwasher pumps
■ RoHS compliant
The board is compatible with 110 and 230 Vac
mains, and includes a power supply stage using
the VIPer12A-E (in buck configuration) to
generate the +15 V and +3.3 V supply voltage
required by the application. The board can be
interfaced with the STM3210B-EVAL (STM32
microcontroller demonstration board) through the
dedicated motor control connector.
Description
The STEVAL-IHM021V2 demonstration board
implements a 100 W, 3-phase inverter for field-
oriented control (FOC) of permanent magnet
synchronous motors (PMSM).
The 3-phase inverter bridge is based on the
STD5N52U power MOSFET with enhanced fast
body-drain recovery diode in a DPAK package,
and the L6390. The L6390 represents the latest in
high-voltage half-bridge gate drivers featuring an
integrated comparator for hardware protection
against overcurrent, overtemperature, etc. The
device also features an embedded operational
amplifier suitable for advanced current sensing.
The STEVAL-IHM021V2 has been specifically
designed to achieve fast and accurate
conditioning of the three shunt resistor-based
motor current feedback network, matching the
requirements typical for high-end applications
such as field-oriented motor control.
As an alternative to the STD5N52U, the
STGD6NC60HD or STGDL6NC60DI IGBT
devices may also be used on the board for
November 2011
Doc ID 17189 Rev 2
1/5
For further information contact your local STMicroelectronics sales office.
www.st.com
5
Schematic diagrams
STEVAL-IHM021V2
1
Schematic diagrams
Figure 1.
Inverter schematic
ꢀꢅꢈꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢀꢅꢈꢄꢄꢀꢁꢊꢇ
ꢁ
ꢃ
ꢁ
ꢃ
ꢁ
ꢃ
ꢁ
ꢃ
ꢁ
ꢃ
ꢁ
ꢃ
ꢃ
ꢀ
!-ꢀꢁꢂꢂꢃꢄVꢂ
2/5
Doc ID 17189 Rev 2
STEVAL-IHM021V2
Figure 2.
Schematic diagrams
Power supply schematic
ꢂ
ꢃ
ꢁ
ꢄ
ꢋ
ꢉ
ꢃ
ꢂ
ꢅ
ꢃ
ꢂ
ꢆ
ꢂ
ꢃ
ꢂ
ꢃ
!-ꢀꢂꢃꢄꢅVꢂ
Doc ID 17189 Rev 2
3/5
Revision history
STEVAL-IHM021V2
2
Revision history
Table 1.
Date
Document revision history
Revision
Changes
25-Feb-2010
1
Initial release.
– Added part number STGDL6NC60DI to the Features and
Description sections of the coverpage.
– Replaced part number STD5NK52ZD with STD5N52U in the
Description section of the coverpage.
10-Nov-2011
2
– Modified Figure 1: Inverter schematic
– Textual modifications in the Description on page 1.
4/5
Doc ID 17189 Rev 2
STEVAL-IHM021V2
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2011 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 17189 Rev 2
5/5
相关型号：
STEVAL-IHM023V2
1 kW 3-phase motor control demonstration board featuring L6390 drivers and STGP10NC60KD IGBT
STMICROELECTR
STEVAL-IHM024V1
100 W 3-phase inverter using the L6390 and STGDL6NC60DI for vector control
STMICROELECTR
STEVAL-IHM025V1
1 kW 3-phase motor control demonstration board featuring the IGBT SLLIMM⢠STGIPL14K60
STMICROELECTR
STEVAL-IHM027V1
Power board with MC connector based on the STGIPS10K60A 10 A, 600 V intelligent power module
STMICROELECTR
STEVAL-IHM029V1
2000 W universal motor control demonstration board based on the STM8S103F2 MCU and T1235H Triac
STMICROELECTR
STEVAL-IHM031V1
3-phase low voltage inverter power board for FOC and scalar motor control based on the STS8DNH3LL MOSFET
STMICROELECTR
STEVAL-IHM032V1
150 W inverter featuring the L639x and STGD3HF60HD for 1-shunt based sinusoidal vector control and trapezoidal scalar control
STMICROELECTR
STEVAL-IHM035V1
3-phase high voltage inverter power board for FOC and scalar motor control based on the STGIPN3H60 (SLLIMMâ¢-nano)
STMICROELECTR
STEVAL-IHM036V1
Low power motor control board featuring the SLLIMM⢠STGIPN3H60 and MCU STM32F100C6T6B
STMICROELECTR
STEVAL-IHP002V1
SmartPlug systems to measure and control AC loads, based on the STM32, ST7540 PLM, and STPM01
STMICROELECTR
STEVAL-IHP002V2
Smartplug system to measure and control AC loads based on the STM32, ST7540 PLM and STPM01
STMICROELECTR
©2020 ICPDF网 联系我们和版权申明