TCM0605T-080-2P-T201 [TDK]
共模滤波器/扼流圈;型号: | TCM0605T-080-2P-T201 |
厂家: | TDK ELECTRONICS |
描述: | 共模滤波器/扼流圈 LTE |
文件: | 总8页 (文件大小:318K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
E M C C o m p o n e n t s
March 2017
Common mode filters
For ultra high-speed differential signal line
(HDMI, DVI, DisplayPort, USB3.0, etc.)
TCM-T series
TCM0605Ttype
TCM0605T
[0202 inch]*
* Dimensions Code JIS[EIA]
(2/8)
E M C C o m p o n e n t s
REMINDERS FOR USING THESE PRODUCTS
Before using these products, be sure to request the delivery specifications.
SAFETY REMINDERS
Please pay sufficient attention to the warnings for safe designing when using these products.
REMINDERS
The storage period is less than 6 months. Be sure to follow the storage conditions (Temperature: 5 to 40°C, Humidity: 20 to 70% RH or
less).
If the storage period elapses, the soldering of the terminal electrodes may deteriorate.
Do not use or store in locations where there are conditions such as gas corrosion (salt, acid, alkali, etc.).
Before soldering, be sure to preheat components.
The preheating temperature should be set so that the temperature difference between the solder temperature and chip temperature
does not exceed 150°C.
Soldering corrections after mounting should be within the range of the conditions determined in the specifications.
If overheated, a short circuit, performance deterioration, or lifespan shortening may occur.
When embedding a printed circuit board where a chip is mounted to a set, be sure that residual stress is not given to the chip due to
the overall distortion of the printed circuit board and partial distortion such as at screw tightening portions.
Self heating (temperature increase) occurs when the power is turned ON, so the tolerance should be sufficient for the set thermal
design.
Carefully lay out the coil for the circuit board design of the non-magnetic shield type.
A malfunction may occur due to magnetic interference.
Use a wrist band to discharge static electricity in your body through the grounding wire.
Do not expose the products to magnets or magnetic fields.
Do not use for a purpose outside of the contents regulated in the delivery specifications.
The products listed on this catalog are intended for use in general electronic equipment (AV equipment, telecommunications
equipment, home appliances, amusement equipment, computer equipment, personal equipment, office equipment, measurement
equipment, industrial robots) under a normal operation and use condition.
The products are not designed or warranted to meet the requirements of the applications listed below, whose performance and/or
quality require a more stringent level of safety or reliability, or whose failure, malfunction or trouble could cause serious damage to
society, person or property.
If you intend to use the products in the applications listed below or if you have special requirements exceeding the range or conditions
set forth in the each catalog, please contact us.
(1) Aerospace/Aviation equipment
(2) Transportation equipment (cars, electric trains, ships, etc.)
(3) Medical equipment
(8) Public information-processing equipment
(9) Military equipment
(10) Electric heating apparatus, burning equipment
(11) Disaster prevention/crime prevention equipment
(12) Safety equipment
(4) Power-generation control equipment
(5) Atomic energy-related equipment
(6) Seabed equipment
(13) Other applications that are not considered general-purpose
applications
(7) Transportation control equipment
When designing your equipment even for general-purpose applications, you are kindly requested to take into consideration securing
protection circuit/device or providing backup circuits in your equipment.
20170306 / cmf_commercial_signal_tcm0605t_en.
(3/8)
E M C C o m p o n e n t s
Product compatible with RoHS directive
Halogen-free
Common mode filters
For ultra high-speed differential signal line
Compatible with lead-free solders
(HDMI, DVI, DisplayPort, USB3.0, etc.)
Overview of TCM0605T type
FEATURES
This product is a thin-film common mode filter with a wide frequency range that can be used for high-speed differential signal interfaces
such as USB3.0 and DisplayPort.
In improved common mode attenuation of 2.4GHz or 5.0GHz, produces a sufficient anti effect to common mode noise of high-
frequency. Also, to realizing remarkable band differential mode transmission(8.0GHz or more), do not have an impact almost to trans-
mission speed difference differential line signal.
APPLICATION
Noise countermeasure for ultra-high-speed differential interfaces (HDMI, DVI, DisplayPort, USB3.0, etc.) for mobile devices and general
consumer products such as smart phones, tablets, digital cameras, and portable music players.
PART NUMBER CONSTRUCTION
TCM
0605
T
-
080
-
2P
-
T
201
L×W×T Dimensions
(mm)
Impedance
() at 100MHz
Product
internal code
T
Number of
lines
Internal
code
Series name
Packaging style
0605
0.65×0.5×0.3
080
200
8
20
2P
2 lines
T
Taping
OPERATING TEMPERATURE RANGE, PACKAGE QUANTITY, PRODUCT WEIGHT
Temperature range
Package quantity
Individual weight
Operating
temperature
Storage
temperature
Type
(pieces/reel)
(°C)
(°C)
(mg)
TCM0605T
–25 to +85
–25 to +85
10,000
0.5
The Storage temperature range is for after the circuit board is mounted.
RoHS Directive Compliant Product: See the following for more details.https://product.tdk.com/info/en/environment/rohs/index.html
Halogen-free: Indicates that Cl content is less than 900ppm, Br content is less than 900ppm, and that the total Cl and Br content is less than 1500ppm.
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
(4/8)
E M C C o m p o n e n t s
TCM0605T type
RECOMMENDED REFLOW PROFILE
Preheating
Soldering
Natural
cooling
Peak
T4
T3
T3
T2
t3
t2
T1
t1
t: Time
Preheating
Temp.
T1
Soldering
Temp.
T3
Peak
Temp.
T4
Time
t1
60 to 120s
Time
t2
10 to 30s
Time
t3
5s max.
T2
180°C
150°C
230°C
245°C
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
(5/8)
E M C C o m p o n e n t s
TCM0605T type
SHAPE & DIMENSIONS
0.50 0.05
1
4
2
3
0.15 0.05
Dimensions in mm
RECOMMENDED LAND PATTERN
CIRCUIT DIAGRAM
0.8
1
2
4
3
• No polarity
0.3
0.2
Dimensions in mm
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
(6/8)
E M C C o m p o n e n t s
TCM0605T type
ELECTRICAL CHARACTERISTICS
HARACTERISTICS SPECIFICATION TABLE
DC resistance Cutoff
frequency
[1 line]
Rated current Rated voltage Insulation
resistance
Part No.
Common mode
attenuation
(dB)
()
(GHz)typ.
(A)max.
(V)max.
(M)min.
30min. @5.0GHz
18min. @4.0 to 6.0GHz
35min. @2.4GHz
18min. @1.9 to 3.3GHz
2.0 30%
2.5 30%
10.0
0.1
10
10
TCM0605T-080-2P-T201
TCM0605T-200-2P-T201
8.0
0.1
10
10
○ Measurement equipment
Measurement item
Product No.
Manufacturer
Common mode impedance
DC resistance
Insulation resistance
4291A
4338A
4339A
Keysight Technologies
Keysight Technologies
Keysight Technologies
* Equivalent measurement equipment may be used.
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
(7/8)
E M C C o m p o n e n t s
TCM0605T type
ELECTRICAL CHARACTERISTICS
IMPEDANCE VS. FREQUENCY CHARACTERISTICS
10000
1000
200 Common mode
100
10
1
200 Differential mode
080 Differential mode
080 Common mode
1
10
100
1000
10000
(
)
Frequency MHz
○ Measurement equipment
Product No.
Manufacturer
4991A
Keysight Technologies
* Equivalent measurement equipment may be used.
INSERTION LOSS VS. FREQUENCY CHARACTERISTICS
0
–10
–20
–30
–30
–40
–50
–60
080 Differential mode
200 Differential mode
080 Common mode
200 Common mode
1
10
100
1000
10000
(
)
Frequency MHz
○ Measurement equipment
Product No.
Manufacturer
E5071B
Keysight Technologies
* Equivalent measurement equipment may be used.
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
(8/8)
E M C C o m p o n e n t s
TCM0605T type
PACKAGING STYLE
REEL DIMENSIONS
2.0 0.5
1.0
9+0.3
ø13 0.2
ø21 0.8
13+1.4
+0
–3
ø180
Dimensions in mm
TAPE DIMENSIONS
2.0
4.0
ø1.5
A
P1
K
Dimensions in mm
Type
A
B
P1
K
TCM0605T
0.63
0.77
2.0
0.35
160min.
Taping
200min.
300min.
Dimensions in mm
Drawing direction
Please be sure to request delivery specifications that provide further details on the features and specifications of the products for proper and safe use.
Please note that the contents may change without any prior notice due to reasons such as upgrading.
20170306 / cmf_commercial_signal_tcm0605t_en.
相关型号:
TCM0605T-200-2P-T201
Data Line Filter,Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G
Common Mode Filters(SMD) For High-speed Differential Signal LineWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-350-2P
Data Line Filter, 2 Function(s), 10V, 0.1A, ROHS COMPLIANT PACKAGE,4-PINSWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-350-2P-T
Data Line Filter, 2 Function(s), 10V, 0.1A, HALOGEN FREE AND ROHS COMPLIANT, SMD, 4 PINWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-650-2P
Data Line Filter, 2 Function(s), 10V, 0.1A, ROHS COMPLIANT PACKAGE,4-PINSWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-650-2P-T
Data Line Filter, 2 Function(s), 10V, 0.1A, HALOGEN FREE AND ROHS COMPLIANT, SMD, 4 PINWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-900-2P
Data Line Filter, 2 Function(s), 10V, 0.1A, ROHS COMPLIANT PACKAGE,4-PINSWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G-900-2P-T
Data Line Filter, 2 Function(s), 10V, 0.1A, HALOGEN FREE AND ROHS COMPLIANT, SMD, 4 PINWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806G9002PT
Common Mode Filters(SMD) For High-speed Differential Signal LineWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806S-120-2P
Data Line FilterWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806S-120-2P-T
Data Line Filter, 2 Function(s), 10V, 0.1A, HALOGEN FREE AND ROHS COMPLIANT PACKAGE-4Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
TCM0806S-350-2P
Data Line FilterWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
TDK
©2020 ICPDF网 联系我们和版权申明