P1595G-AB5-R [UTC]
200KHZ, 1.5A PWM BUCK DC/DC CONVERTER; 为200KHz , 1.5A PWM降压型DC / DC转换器型号: | P1595G-AB5-R |
厂家: | Unisonic Technologies |
描述: | 200KHZ, 1.5A PWM BUCK DC/DC CONVERTER |
文件: | 总6页 (文件大小:253K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
UNISONIC TECHNOLOGIES CO., LTD
P1595
LINEAR INTEGRATED CIRCUIT
200KHZ, 1.5A PWM BUCK
DC/DC CONVERTER
DESCRIPTION
The UTC P1595 is a monolithic integrated circuit intended for the
use of a step-down DC/DC converter and it can drive a 1.5A load
without additional transistors.
The internal compensation makes feedback control having good
line and load regulation without external design. The external
shutdown function can be controlled by logic level and then enter the
standby mode.
The UTC P1595 features a guaranteed +3% tolerance on
output voltage under specified input voltage and output load
conditions. Thermal shutdown protection is designed to prevent over
temperature operating from damage while current limit protection is
against over current operating of the output switch. The switching
frequency will be reduced if current limit function occurs and feedback
voltage (VFB) drops below 0.5V. The UTC P1595 works at a 200kHz
switching frequency so it allows smaller sized filter components.
FEATURES
* Output Voltage In Adjustable Output Version.
* Adjustable Version Output Voltage Range: 0.75V ~ 22V With+3%
Accuracy.
* Short Circuit Protect
* Fixed Switching Frequency: 200KHZ.
* On/Off Shutdown Control Input.
* Voltage Mode Non-Synchronous Pulse Width Modulation (PWM)
Control.
* Thermal-Shutdown And Current-Limit Protection.
* Operating Voltage Can Be Up To 24V.
* 1.5A Output Load Current.
* Low Power Standby Mode.
* Built-In Switching Transistor
ORDERING INFORMATION
Ordering Number
Package
SOT-89-5
Packing
Lead Free
Halogen Free
P1595G-AB5-R
Tape Reel
P1595L-AB5-R
www.unisonic.com.tw
Copyright © 2011 Unisonic Technologies Co., Ltd
1 of 6
QW-R103-047.C
P1595
LINEAR INTEGRATED CIRCUIT
PIN CONFIGURATION
PIN DESCRIPTION
PIN NO.
PIN NAME
DESCRIPTION
1
2
3
4
5
SW
GND
FB
Switching Output
Ground
Feedback Voltage
On/Off Pin
EN
VCC
Operating Voltage Input
BLOCK DIAGRAM
VCC
EN
CURRENT
SOURCE
BIAS
0.75V
REFERENCE
2.5V
REGULATOR
START
UP
+
COMP.
-
+
EA
-
+
FB
PWM
latch
Driver
-
Thermal
SW
-
200KHz
OSC.
Shutdown
0.4V
GND
+
UNISONIC TECHNOLOGIES CO., LTD
2 of 6
QW-R103-047.C
www.unisonic.com.tw
P1595
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATING (unless otherwise specified)
PARAMETER
SYMBOL
VCC
RATINGS
+26
UNIT
Supply Voltage
V
V
V
V
ON/OFF Pin Input Voltage
Feedback Pin Voltage
VEN
-0.3 ~ VCC
-0.3 ~ 12
4.5~24
VFB
Operating Supply Voltage
VOP
Output Voltage to Ground
Power Dissipation (Note 1)
VOUT
PD
-0.8
690
V
mW
TA=25°C
Operating Temperature
TOPR
-20 ~ +125
°C
Storage Temperature
TSTG
-65 ~ +150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
THERMAL DATA
PARAMETER
SYMBOL
θJA
RATINGS
180
UNIT
°C/W
°C/W
Junction to Ambient (Note 1)
Junction to Case (Note 1)
θJC
38
Note: 1. It’s Measured with the PCB copper area (need connect to VSS pins) of approximately 1.5 in2(Multi-layer)
ELECTRICAL CHARACTERISTICS (TA=25°C, VCC=12V, ILOAD=0.2A, unless otherwise specified)
PARAMETER
SYMBOL
VFB
TEST CONDITIONS
IOUT=0.2A
OUT=1.5A, No outside circuit
VFB=0V force driver on
VFB=1.2V force driver off
IOUT=0.1A
MIN
TYP
MAX UNIT
Feedback Voltage
0.728 0.750 0.773
V
I
Saturation Voltage
VSAT
1.2
1.5
V
Quiescent Current
IQ
4
-10
2
8
mA
nA
μA
Feedback Bias Current
Shutdown Supply Current
IFB
ISD
-50
10
VEN=0V
Pear current, No outside circuit
VFB=0V force driver on
No outside circuit
VFB=1.0V force driver off
VCC=24V force driver off
Current Limit
I(LIMIT)
1.8
A
SW pin=0V
SW pin=-0.8V
-50
μA
SW Pin Leakage
Current
ISW(LEAK)
-5
mA
Oscillator Frequency
Oscillator Frequency Circuit Protect
of Short
FOSC
FSCP
140
200
260
KHz
(Adjustable) When VFB<0.5V
80
KHz
Max. Duty Cycle (ON)
Min. Duty Cycle (OFF)
EN Pin Logic Input Threshold
Voltage
VFB=1.2V force driver off
VFB=0V force driver on
High (regulator ON)
Low (regulator OFF)
VEN=2.5V (ON)
0
%
%
DC
100
1.2
1.2
20
VIH
VIL
IH
2.0
V
0.5
V
EN pin Logic Input Current
EN pin Input Current
Thermal Shutdown Temp
μA
μA
°C
IL
VEN=0.3V (OFF)
-5
TSD
135
UNISONIC TECHNOLOGIES CO., LTD
3 of 6
QW-R103-047.C
www.unisonic.com.tw
P1595
LINEAR INTEGRATED CIRCUIT
TYPICAL APPLICATION CIRCUIT
Adjustable Output Voltage Version
R1
R2
⎛
⎞
⎟
VOUT=V × 1+
, V =0.75V. R2=0.75K~4K
FB
⎜
FB
⎝
⎠
Resistor select for output voltage setting
VOUT
5V
R2
1.2K
2K
R1
6.8K
6.8K
4.7K
3K
3.3V
2.5V
1.8V
1.5V
1.3V
1.2V
2K
2K
2K
2K
2K
1.5K
1.2K
2K
L1 recommend value (VIN=12V, IOUT=1.5A,)
VOUT
1.8 V
2.5V
3.3V
5V
L1 Value
22μH
22μH
33μH
33μH
FUNCTION DESCRIPTIONS
Pin Functions
Vcc
It provides the IC switching regulator with positive input supply. This pin is used to supply the switching currents
needed by the regulator and a suitable input bypass capacitor must be connected at this pin.
GND
Circuit ground.
SW
Internal switch. The voltage at this pin switches between (+VCC-VSAT) and approximately-0.5V, with a duty cycle of
approximately VOUT / VCC. To minimize coupling to sensitive circuitry, you should minimize the PC board copper area
connected to this pin.
Feedback
Senses the regulated output voltage to complete the feedback loop.
EN
Using logic level signals to allow the switching regulator circuit to be shutdown, which dropping the total input
supply current to approximately 10uA. Shut the regulator down through pulling this pin below a threshold voltage of
approximately 0.5V, turn the regulator on through pulling this pin above 2.0V (up to VCC MAX).
UNISONIC TECHNOLOGIES CO., LTD
4 of 6
QW-R103-047.C
www.unisonic.com.tw
P1595
LINEAR INTEGRATED CIRCUIT
TYPICAL CHARACTERISTICS
1. Startup during power on
2. Low-frequency triangle wave control enable pin
VCC=24V
1V
0
2V
0
0
2500
5000
Time (500ms/div)
3. Control enable pin with power supply to normal
UNISONIC TECIES CO., LTD
5 of 6
QW-R103-047.C
www.unisonic.com.tw
P1595
LINEAR INTEGRATED CIRCUIT
TYPICAL CHARACTERISTICS(Cont.)
4. Transient response with step load
VCC=12V
VCC=24V
50mV
0
50mV
0
-50mV
-50mV
0
1000
2000
0
500
1000
Time (200µs/div)
Time (100µs/div)
5. Efficiency
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
6 of 6
QW-R103-047.C
www.unisonic.com.tw
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明