DS850-3 [ARTESYN]
Distributed Power Bulk Front-End;
| 型号： | DS850-3 |
| 厂家： | 
ARTESYN TECHNOLOGIES |
| 描述： | Distributed Power Bulk Front-End 输出元件 |
| 文件： | 总4页 (文件大小：575K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
POWER
Data Sheet
DS650/DS850
Distributed Power Bulk Front-End
Total Input
Power: +3.3 Vdc Standby Output
Wide Range 90 - 264 Vac
650/850 Watts
Output Voltage: 12, 24 and 48 V
SPECIAL FEATURES
Active power factor correction
EN61000-3-2 harmonic compliance
Inrush control
1U X 2U form factor
15.4 W/ in3
12 Vdc, 24 Vdc and 48 Vdc output
Available in +3.3 V and +5.0 V standby
output versions
Electrical Specifications
Input
No minimum load required
Hot plug operation
N + 1 redundant
Input range
90 - 264 Vac (wide range)
47 - 63 Hz, single phase AC
Internal OR’ing fets
Frequency
Active current sharing (10 - 100% load)
Built-in cooling fans (40 mm x 28 mm)
I2C communication interface bus
EEPROM for FRU data
Inrush current
Efficiency
55 A maximum inrush current
> 82% typical at full load, high line
FCC Subpart J EN55022 Class B
FCC Subpart J EN55022 Class B
0.99 typical
Conducted EMI
Radiated EMI
Power factor
Leakage current
Hold up time
Output
Amber/Green bi-color LED status
Internal fan speed control
Fan Fail Tach output signal
One year warranty
1.40 mA @ 240 Vac
20 ms minimum
SAFETY
Main DC voltage
+12 V @ 52.5 A/70.0 A
+24 V @ 26.3 A/35.0 A
+48 V @ 13.1 A/17.5 A
UL/cUL 60950 (UL Recognized)
NEMKO+ CB Report EN60950
EN60950
Standby
+3.3 vsb @ 6 A (5 V @ 4 A available)
Factory Set, no pot adjustments
CE Mark
Adjustment range
Regulation
China CCC
Main output; +5%/-5%
+3.3 vsb; +5%/-5%
Overcurrent
Over oltage
110% - 150% of nominal Latches off if overcurrent lasts
over 1 second, otherwise it is auto recovery.
+3.3 vsb, 9 A max (hiccup mode)
110% - 120% of nominal
+3.3 vsb; 3.76 - 4.30 Vdc
Undervoltage
75% - 90% of nominal
Turn-on delay
2 Second max, 5 - 50 mS, Monotonic Rise
5 - 50 mS, Monotonic Rise
Main output rise time
DS650/DS850 Data Sheet
Logic Control
PS_SEATED
PWR GOOD
AC OK
TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed.
Active TTL HiIGH when output is within regulation limits.
A LOW logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 5mS early warningsig-
nal before main output loss of regulation.
Temp OK
A TTL logic HIGH, when operating within allowable temperature range.
PS_INHIBIT/PS_KILL
This signal is connected to a short pin on the PSU
When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin
will be pull low by the system and turn the power supply on only after all other power supply pins have seated.
Environmental Specifications
Operating temperature:
0 to 50° C, unimpeded airflow
-40 °C to +85 °C
Storage temperature:
Altitude, operating 10,000ft.
Electromagnetic susceptibility/Input transients:
-EN61000-3-2, -3-3
-EN61000-4-2, 4.3, 4-4, -4-5, 4-11
-EN55024: 1998
RoHS & lead-free compliant (no tantalum caps.)
Humidity:
20 to 90% RH, non-condensing
Shock and vibration specificatons complies with Astec Std. Specifications.
MTBF (Demonstrated)
500K Hrs at full load, 40 °C
Ordering Information
Nominal Output
Voltage Set Point
Set Point
Tolerance**
Total
Regulation
Minimum
Current
Maximum
Current
Output Ripple
P/P
Output
DS650-3
DS650-5
DS650-9
DS850-3
DS850-5
DS850-9
12.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
52.5 A
6.0 A
120 mV
50 mV
24.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
26.3 A
6.0 A
240 mV
50 mV
48.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
13.1 A
6.0 A
480 mV
50 mV
12.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
70.0 A
6.0 A
120 mV
50 mV
24.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
35.0 A
6.0 A
240 mV
50 mV
48.0 Vdc
3.3 vsb*
0.2%
1%
5%
5%
0 A
0 A
17.5 A
6.0 A
480 mV
50 mV
*For 5 vsb, please contact marketing department.
**Set point tolerance is measured at nominal voltage, 50% load and room temperature.
DS650/DS850 Data Sheet
Mechanical Drawing
Power Supply Condition
LED Green/Amber
OFF
No AC power to all PSU
AC present/Standby outpus ON, Main output OFF
Power supply DC outputs ON and OK
Main output failure (OCP, OVP, UVP)
Fan Fail, OTP, Standby output OCP/UVP
Blinking Green
Solid Green
Blinking Amber
Solid Amber
DS650/DS850 Data Sheet
DC Output Connector Pinout Assignment
Male connector as viewed from the rear of the supply:
D1
C1
B1
A1
D2
C2
B2
A2
D3
C3
B3
A3
D4
C4
B4
A4
D5
C5
B5
A5
D6
C6
B6
A6
PB1
PB2
PB3
PB4
PB5
PB6
P1 - Power Supply Side
Mating Connector (System Side)
1
FCI Power Blade 51721 series
51721-10002406AA
1
FCI Power Blade
51741-10002406CC
Strait Pins
2
Molex Power Connector
SD-87667 series
87667-7002
2
FCI Power Blade
51761-10002406AA
Right Angle
Pin Assignments
Pin Assignments
Pin
PB 1
PB 2
PB 3
PB 4
PB 5
PB 6
A1
Signal Name
Pin
C1
C2
C3
C4
C5
C6
D1
D2
D3
D4
D5
D6
Signal Name
MAIN O/P RETURN
MAIN O/P RETURN
MAIN O/P RETURN
+ MAIN O/P
SDA (I2C Data Signal)
SCL (I2C Clock Signal)*
POWER GOOD
FAN FAIL (Fan Fail Signal)
+3V3 STAND-BY
+ MAIN O/P
+ MAIN O/P
+3V3SB RETURN
PS_ON
A0 (I2C Address BIT 0 Signal)
A1 (I2C Address BIT 1 Signal)
S_INT (Alarm)
A2
MAIN O/P V RMT SENSE RETURN
TEMP_OK
A3
A4
PS_SEATED ( Power Supply Seated)
+3V3 STAND-BY
+3V3 STAND-BY RMT SENSE
+3V3 STAND-BY
A5
A6
+3V3SB RETURN
+3V3SB RETURN
B1
AC_OK (AC Input Present)
MAIN O/P RMT SENSE
MAIN O/P CURRENT SHARE
PS_INHIBIT
*Supports I2C standard mode (100 kHz) only
B2
B3
B4
B5
+3V3 STAND-BY
B6
+3V3SB RETURN
WORLDWIDE OFFICES
Asia (HK)
Americas
Europe (UK)
14/F, Lu Plaza
2900 S.Diablo Way
Tempe, AZ 85282
USA
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
2 Wing Yip Street
Kwun Tong, Kowloon
Hong Kong
+1 888 412 7832
www.artesyn.com
+852 2176 3333
+44 (0) 1384 842 211
While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn
Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of
this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn
Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other
names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners.
© 2015 Artesyn Embedded Technologies, Inc.
For more information: www.artesyn.com/power
For support: productsupport.ep@artesyn.com
DS650/DS850-DS 08May2015
相关型号：
©2020 ICPDF网 联系我们和版权申明