GLS86FA032G1-BN001 [GREENLIANT]
Industrial Grade mSATA ArmourDrive;
| 型号： | GLS86FA032G1-BN001 |
| 厂家： | 
Greenliant |
| 描述： | Industrial Grade mSATA ArmourDrive |
| 文件： | 总7页 (文件大小：478K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
Features
• Industry Standard mini-Serial ATA (miniSATA
• Expanded Data Protection
or mSATA) Host Interface
-
Added data security through user-selectable
protection zones
1)
-
-
-
SATA 1.5 Gb/s or SATA 3.0 Gb/s
ATA/ATAPI-8 compliant
Supports 48-bit address feature set
• Integrated Voltage Detector
-
Detects supply voltage fluctuations and
generates reset during power-up and power-
down to prevent inadvertent writes
• Performance
-
Sequential data read -
• Supports SMART Commands
• Supports TRIM Commands
• 20-Byte Serial Number
Up to 120 MByte/sec*
Sequential data write -
Up to 80 MByte/sec*
* measured using 128 KByte transfer size
-
-
-
Factory pre-programmed 10-Byte unique ID
User-programmable 10-Byte ID
• Power Management
-
-
-
3.3V power supply
Host SATA interface power management
Immediate disabling of unused circuitry
• Robust Built-in ECC
• NAND Configuration
-
1 bit per cell (SLC)
without host intervention
• Temperature Range
2)
• Power Specifications
-
Industrial: -40°C to 85°C
-
Active mode:
• JEDEC standard MO-300 mSATA form factor
1070mW typical (GLS86FA032G1)
820mW typical (GLS86FA016G1)
810mW typical (GLS86FA008G1)
Idle/Standby mode: as low as 380mW typical
-
29.85 mm x 50.80 mm x 4.8 mm
• All Devices are RoHS Compliant
1) Current product revision supports SATA Revision 1.x with
host transfer rate of up to 1.5 Gb/s (i.e. SATA 1.5 Gb/s).
SATA 3.0 Gb/s refers to SATA Revision 2.x and will be
supported by our planned future product revisions.
2) For management of the Sleep Mode, please refer to
“SATA NANDrive Application Design Guide.”
-
-
Sleep mode:
as low as 110mW typical
Product Description
The GLS86FA008G1 / 016G1 / 1032G1 Industrial
Grade miniSATA (mSATA) ArmourDrive™ solid state
drive modules (referred to as “mSATA ArmourDrive” in
this fact sheet) are high-reliability, fully integrated solid
state drives. They combine an 8, 16 or 32 GByte
SATA NANDrive™ and power interrupt data
protection circuit on a printed circuit board (PCB)
module. These products are ideal for portable
applications that require removable form factor and
more reliable data storage.
The integrated NAND flash controller with built-in
advanced
NAND
management
firmware
communicates with the host through the standard
SATA protocol. It does not require any additional or
proprietary software such as the Flash File System
(FFS) and Memory Technology Driver (MTD).
mSATA ArmourDrive is pre-programmed with a 10-
Byte unique serial ID and has the option of
programming an additional 10-Byte serial ID for even
greater system security.
SATA-interface solid state mass storage technology is
widely used in portable and industrial computers, set-
top boxes, test and measurement instrumentation,
multi-functional printers, video and audio recorders,
network servers and car infotainment systems.
mSATA ArmourDrive’s advanced NAND management
technology enhances data reliability and security,
improves endurance and accurately estimates the
remaining life of the NAND flash devices. This
innovative technology combines robust NAND
controller hardware error correction capabilities with
advanced wear-leveling algorithms and bad block
management to significantly extend the life of the
product.
mSATA ArmourDrive is a removable solid state drive
(SSD) that provides the functionality and compatibility
of a complete SATA hard disk drive (HDD) in a 29.85
mm x 50.80 mm form factor. These products surpass
traditional storage in their small size, security,
reliability, ruggedness and low power consumption.
mSATA ArmourDrive is offered in a standard JEDEC
52-pin PCB module form factor.
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
1
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
1.0
GENERAL DESCRIPTION
Each mSATA ArmourDrive module contains a NANDrive multi-chip package, which integrates a SATA NAND
flash memory controller with up to eight discrete NAND flash die. Refer to Figure 2-1 for the mSATA ArmourDrive
block diagram.
1.1.5 Power Interrupt Data Protection
1.1
Optimized mSATA ArmourDrive
Dedicated power failure detection and backup power
circuitry are built in to prevent data integrity issues
due to sudden power interruptions.
The heart of mSATA ArmourDrive is the SATA NAND
flash memory controller which translates standard
SATA signals into flash media data and control
signals. The following components contribute to
mSATA ArmourDrive’s operation.
1.1.6 Error Correction Code (ECC)
High performance is achieved through optimized
hardware error detection and correction.
1.1.1 Microcontroller Unit (MCU)
The MCU translates SATA commands into data and
control signals required for flash media operation.
1.1.7 Serial Communication Interface (SCI)
The Serial Communication Interface (SCI) is designed
for error reporting. During the product development
stage, it is recommended to provide the SCI port on
the PCB to aid in design validation.
1.1.2 Internal Direct Memory Access (DMA)
mSATA ArmourDrive uses internal DMA allowing
instant data transfer from/to buffer to/from flash media.
This implementation eliminates microcontroller
overhead associated with the traditional, firmware-
based approach, thereby increasing the data transfer
rate.
1.1.8 Multi-tasking Interface
The multi-tasking interface enables concurrent Read,
Program and Erase operations to multiple NAND flash
media.
1.1.3 Power Management Unit (PMU)
The PMU controls the power consumption of mSATA
ArmourDrive. The PMU dramatically reduces the
power consumption of mSATA ArmourDrive by putting
the part of the circuitry that is not in operation into
1.2
Advanced NAND Management
mSATA ArmourDrive’s integrated controller uses
advanced wear-leveling algorithms to substantially
increase the longevity of NAND flash media. Wear
caused by data writes is evenly distributed in all or
select blocks in the device that prevents “hot spots” in
locations that are programmed and erased extensively.
This effective wear-leveling technique results in
optimized device endurance, enhanced data retention
and higher reliability required by long-life applications.
3)
sleep mode.
The Flash File System handles inadvertent power
interrupts and has auto-recovery capability to ensure
mSATA ArmourDrive firmware integrity. For regular
power management, the host must send an
IDLE_IMMEDIATE command and wait for command
ready before powering down mSATA ArmourDrive.
3) For management of the Sleep Mode, please refer to
“SATA NANDrive Application Design Guide.”
1.1.4 Embedded Flash File System
The embedded flash file system is an integral part of
mSATA ArmourDrive. It contains MCU firmware that
performs the following tasks:
1. Translates host side signals into flash media
writes and reads
2. Provides flash media wear leveling to spread the
flash writes across all memory address space to
increase the longevity of flash media
3. Keeps track of data file structures
4. Manages system security for the selected
protection zones
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
2
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
2.0
FUNCTIONAL BLOCKS
ArmourDrive
NAND Controller
MCU
mSATA
SRAM Buffer
Flash Media I/F
NAND I/F
HOST I/F
NAND
Flash
ECC
Internal DMA
Power Interrupt Data
Protection Circuitry
PMU
SCI
Figure 2-1: mSATA ArmourDrive Block Diagram
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
3
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
3.0
3.1
APPENDIX
Product Ordering Information
GLS 86 FA
XX XX
xxx G1 - BNxxx
XXX XX - XXXXX
Ordering Code 4)
BNxxx = AmourDrive revision
NAND Configuration
1 = 1 bit per cell (SLC)
GByte or TByte Designator
G = GByte
Capacity
008 = 8 GByte
016 = 16 GByte
032 = 32 GByte
Product Generation
A = First generation
Form Factor
F = Full length (mSATA)
Product Series
86 = mSATA ArmourDrive
4) Note that the top side marking on the package typically does not include ordering codes (e.g. BNxxx), unless it is a special custom
specification (C-SPEC) required by the end-customer to be marked on the device.
Valid Combinations
Valid product combinations are those that are in the mass production or will be in the mass production. Consult your Greenliant sales
representative to confirm availability of the valid combinations and to determine availability of new product combinations.
Table 3-1: mSATA ArmourDrive Product Valid Ordering Numbers
Capacity Operating Temperature
Part Number
Form Factor
GLS86FA008G1-BN001
GLS86FA008G1-BN004*
GLS86FA016G1-BN001
GLS86FA016G1-BN004*
GLS86FA032G1-BN001
GLS86FA032G1-BN004*
JEDEC MO-300 (full length)
JEDEC MO-300 (full length)
JEDEC MO-300 (full length)
JEDEC MO-300 (full length)
JEDEC MO-300 (full length)
JEDEC MO-300 (full length)
8GB
Industrial (-40°C to 85°C)
Industrial (-40°C to 85°C)
Industrial (-40°C to 85°C)
16GB
32GB
* BN004 products include enhanced support for TRIM command and power management in Windows environments.
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
4
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
3.2
Board Diagrams
TOP VIEW
SIDE VIEW
BOTTOM VIEW
Note:
All dimensions are in millimeters, unless otherwise specified.
Tolerances on all dimensions are ± 0.15 mm, unless otherwise specified.
Figure 3-1: mSATA ArmourDrive Dimensions
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
5
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
TOP VIEW
BOTTOM VIEW
Note:
All dimensions are in millimeters, unless otherwise specified.
Tolerances on all dimensions are ± 0.15 mm, unless otherwise specified.
Figure 3-2: mSATA ArmourDrive Connector
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
6
GLS86FA008G1 / 016G1 / 032G1
Industrial Grade mSATA ArmourDrive™
Fact Sheet 02.000
April 2018
3.3
Revision History
Table 3-2: Revision History
Revision
Description
Date
01.000
01.100
01.101
02.000
Initial release as Fact Sheet for GLS86FA008G1 / 016G1 / 032G1
Updated Power Specifications
July 18, 2013
October 04, 2013
December 10, 2013
April 16, 2018
Fixed typos on first page
Added ordering code BN004
© 2018 Greenliant. All rights reserved.
Greenliant and the Greenliant logo are registered trademarks, and ArmourDrive and NANDrive are trademarks
of Greenliant. All other trademarks and registered trademarks are the property of their respective owners.
Specifications are subject to change without notice. Memory sizes denote raw storage capacity; actual usable
capacity may be less.
Greenliant makes no warranty for the use of its products other than those expressly contained in the Greenliant
Terms and Conditions of Sale.
www.greenliant.com
These specifications are subject to change without notice.
© 2018 Greenliant
04/16/2018
S71446-01
7
相关型号：
©2020 ICPDF网 联系我们和版权申明