NSVS1129 [NJRC]
SAW Filter, 1 Function(s), 915MHz,;
| 型号： | NSVS1129 |
| 厂家： | 
NEW JAPAN RADIO |
| 描述： | SAW Filter, 1 Function(s), 915MHz, LTE |
| 文件： | 总4页 (文件大小：271K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
NSVS1129 Apr. 2013
NewJRC SAW FILTER
NSVS1129
Application
915MHz ISM
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.1.
Table 1. Electrical Specifications
Item
Spec.
Typ.
50Ω
915MHz
3.0dB
7.0dB
1.0dB
1.8
Input and Output Impedance
Nominal Center Frequency (f0)
Insertion Loss
-
-
910MHz~918.5MHz
3.5dB max.
909.5MHz~918.5MHz *1 8.0dB max.
Response Variation
910MHz~918.5MHz
910MHz~918.5MHz
500MHz~860MHz
935MHz
1.5dB max.
2.5 max.
Input and Output VSWR
Out of Band Rejection
(Relative to Through Level)
50dB min.
20dB min.
35dB min.
55dB
25dB
40dB
1500MHz~2000MHz
(Operating Temperature Range: -10~+60ºC)
*1(Operating Temperature Range: -40~+85ºC)
Maximum Rating: (Table 2)
Table 2. Maximum Ratings
Item
Rating
+10dBm
7.5V
Maximum Input Power
Maximum DC Voltage
Operating Temperature Range
Storage Temperature
-40~+85ºC
-40~+85ºC
Mechanical Specifications: (Fig.2)
Package is designed as small as 3.5x3.5x1.0[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
http://www.njr.co.jp/products/device/index.html
http://www.njr.com/products/device/index.html
(Japanese)
(English)
NSVS1129 Apr. 2013
IN
50Ω
OUT
50Ω
8
7
1
2
SAW 6
3 4 5
Fig.1 Measuring circuit
(a)
3. 5 ±0. 2
(
)
1
(b )
J45
(2)
MS
(
)
3
Marking
(1) Manufacture’s Mark
(2) Lot Number
(a) Year
(0. 9 5)
(0 .8)
[5 x]
4
(b) Month
3
2
*Oct.---
X
Y
Z
5
6
7
Nov.---
(0. 6 )
Dec.---
(3) Part number Mark
Pin no.
Connection
GND
IN
1
1
2
3
4
5
6
7
8
8
Fig.2 Package dimensions (in mm)
GND
GND
GND
OUT
4.3
0.8
1.3
[6x]
GND
GND
Via-Hole( 0.3)
Φ
Fig.3 Desirable land area (in mm)
NSVS1129 Apr. 2013
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -40ºC or more than +85ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 10 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
2. The information contained herein may be changed without prior notice. It is
therefore advisable to contact New Japan Radio Company before proceeding
with the design of equipment incorporating this product.
3. The products are designed to be used with ordinary electronic equipment (data
and communications equipment, office equipment, audio-video equipment,
measuring instruments, etc). New Japan Radio Company does not assume any
liability for the case using the products with the application required high
reliability or safety extremely (such as space equipment, sea-bottom equipment,
medical equipment etc). When intending to use any our product please
contact our sales representatives in advance.
NSVS1129 Apr. 2013
FREQUENCY CHARACTERISTICS
S21
0
0
20
40
60
80
100
2
4
6
8
10
CH1 : center 915 span 200
CH2 : center 915 span 200
S11
S22
S22
S11
11
9
11
9
7
7
5
5
3
3
1
1
815
1015
815
1015
Frequency [MHz]
Frequency [MHz]
S21
0
20
40
60
80
100
0.3
3000
Frequency [MHz]
相关型号：
©2020 ICPDF网 联系我们和版权申明