UPD98414 [ETC]
Telecommunication IC ; 电信IC\n型号: | UPD98414 |
厂家: | ETC |
描述: | Telecommunication IC
|
文件: | 总2页 (文件大小:39K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
µPD98414
2.4Gbps ATM SONET FRAMER
(NEASCOT-P70TM)
NEASCOT-P70 device is a 2.4Gbits/s SONET STS-48c/ SDH STM-16c framer. The device performs all functions necessary
to insert and extract ATM cells from STS-48c/ STM-16c frame. It is ideal for high-speed ATM switch of LAN or WAN.
Features
• Supplies the TC (Transmission Convergence) sublayer functions recommended by the ATM Forum and ITU-T.
• Supports the concatenation frame of 2.4 Gbps SONET STS-48c/SDH STM-16c.
• ATM layer interface complies with standard UTOPIA-L3
• Provides abundant OAM functions.
• Can access all overhead areas of transmit/receive frame.
• Transmit/Receive message buffer for J0/J1 trace messages (16-byte or 64-byte length)
Support frame
Concatenation frame of 2.4 Gbps SONET STS-48c/SDH STM-16c
32-bit, 8 M to 104 MHz, LVTTL level FIFO interface
15-cell transmit/receive FIFO
ATM layer interface
Cell format
Supports 52-byte/56-byte cell formats.
Prefixes one-word TAG area to receive cell.
Line side interface
CPU interface
16-bit, 155.52 MHz, PECL level
Recommended MUX/DUMUX device; AMCC S3043, S3044, etc.
Two modes can be selected.
16-bit Intel-compatible mode/16-bit Motorola-compatible mode
Supports two types of overhead interfaces.
Overhead interface
• Overhead byte insert/extract registers.
• Overhead byte insert/extract interfaces.
OAM function
Test function
Fault: Detection of LOS, OOF, LOF, LOP, OCD, and LCD
Alarm: Detection and transmission of APS, Line AIS, Line RDI, Path AIS, and Path RDI
Receive APS signal and Signal Label (C2 byte) monitoring functions
Bit error rate monitoring function
Supports loopback function (ATM layer loopback/Circuit side loopback)
Supports an error generation pseudo frame transmission function for testing
Supports JTAG boundary scan test (IEEE1149.1)
3.3 V single power source/0.35 µm CMOS
Power supply voltage/Process
Package
352-pin plastic BGA (cavity down advanced type)(35 × 35)
System Configuration Example
Transmit
Microprocessor
Overhead
Bus (16-bit)
Insert
Ref.Clk
16-bit PECL
E/O
O/E
MUX
32
NEC
NEASCOT-P70
µPD98414
clk
ATM Layer I/F
(UTOPIA-L3)
32
16
DEMUX
clk
Alarm
Receive
Overhead
Extract
JTAG
The information in this document is subject to change without notice. Before using this document, please
confirm that this is the latest version.
Not all devices/types available in every country. Please check with local NEC representative for
availability and additional information.
Document No. S14254EJ3V0PF00 (3rd edition)
Data Published November 2001 NS CP(K)
Printed in Japan
1999
ATM Layer Device
Block Diagram
Rx ATM Layer Interface
Tx ATM Layer Interface
POUT0
POUT1
POUT2
POUT3
POUT4
PIN0
MADD[8]
MD[16]
BMODE
DS_B
ACK2S_B
ACK3S_B
RW
PIN1
PIN2
CS_B
PHINT_B
RESET_B
LOSS
OOFS
LOFS
LOPS
LCDS
LAISS
PAISS
LRDIS
PRDIS
B1ERS
B2ERS
TLAIS
TPAIS
TLRDI
TPRDI
RSOHCK (25M)
RSOHFP
TSOHCK(25M)
TSOHFP
TSOHD[4]
TSOHAV
RSOHD[4]
RSOHAV
RPOHCK(576K)
RPOHFP
TPOHCK(576K)
TPOHFP
TPOHD
RPOHD
RPOHAV
TPOHAV
32
32
TCS(77M)
RCS(19M)
JCK
JDI
JMS
JRST_B
JDO
Line Interface
MUX/DEMUX Chip
NEASCOT-P70 is a trademark of NEC Corporation.
•
The information in this document is current as of November, 2001. The information is subject to
change without notice. For actual design-in, refer to the latest publications of NEC's data sheets or
data books, etc., for the most up-to-date specifications of NEC semiconductor products. Not all
products and/or types are available in every country. Please check with an NEC sales representative
for availability and additional information.
•
•
No part of this document may be copied or reproduced in any form or by any means without prior
written consent of NEC. NEC assumes no responsibility for any errors that may appear in this document.
NEC does not assume any liability for infringement of patents, copyrights or other intellectual property rights of
third parties by or arising from the use of NEC semiconductor products listed in this document or any other
liability arising from the use of such products. No license, express, implied or otherwise, is granted under any
patents, copyrights or other intellectual property rights of NEC or others.
•
•
•
Descriptions of circuits, software and other related information in this document are provided for illustrative
purposes in semiconductor product operation and application examples. The incorporation of these
circuits, software and information in the design of customer's equipment shall be done under the full
responsibility of customer. NEC assumes no responsibility for any losses incurred by customers or third
parties arising from the use of these circuits, software and information.
While NEC endeavours to enhance the quality, reliability and safety of NEC semiconductor products, customers
agree and acknowledge that the possibility of defects thereof cannot be eliminated entirely. To minimize
risks of damage to property or injury (including death) to persons arising from defects in NEC
semiconductor products, customers must incorporate sufficient safety measures in their design, such as
redundancy, fire-containment, and anti-failure features.
NEC semiconductor products are classified into the following three quality grades:
"Standard", "Special" and "Specific". The "Specific" quality grade applies only to semiconductor products
developed based on
a
customer-designated "quality assurance program" for
a specific application. The
recommended applications of
a
semiconductor product depend on its quality grade, as indicated below.
Customers must check the quality grade of each semiconductor product before using it in
application.
a particular
"Standard": Computers, office equipment, communications equipment, test and measurement equipment, audio
and visual equipment, home electronic appliances, machine tools, personal electronic equipment
and industrial robots
"Special": Transportation equipment (automobiles, trains, ships, etc.), traffic control systems, anti-disaster
systems, anti-crime systems, safety equipment and medical equipment (not specifically designed
for life support)
"Specific": Aircraft, aerospace equipment, submersible repeaters, nuclear reactor control systems, life
support systems and medical equipment for life support, etc.
The quality grade of NEC semiconductor products is "Standard" unless otherwise expressly specified in NEC's
data sheets or data books, etc. If customers wish to use NEC semiconductor products in applications not
intended by NEC, they must contact an NEC sales representative in advance to determine NEC's willingness
to support a given application.
(Note)
(1) "NEC" as used in this statement means NEC Corporation and also includes its majority-owned subsidiaries.
(2) "NEC semiconductor products" means any semiconductor product developed or manufactured by or for
NEC (as defined above).
M8E 00. 4
相关型号:
UPD98414F2-RN1
IC,ATM/SONET FRAMER,CMOS,BGA,352PIN,PLASTICWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
RENESAS
UPD98421F1-GA1
Content Addressable SRAM, 8KX64, MOS, PBGA240, 16 X 16 MM, PLASTIC, FBGA-240Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
RENESAS
UPD98421F1-GA1-A
8KX64 CONTENT ADDRESSABLE SRAM, PBGA240, 16 X 16 MM, PLASTIC, FBGA-240Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
RENESAS
UPD98431
Controller Miscellaneous - Datasheet ReferenceWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
ETC
UPD98431S1-F6
8 CHANNEL(S), 100Mbps, LOCAL AREA NETWORK CONTROLLER, PBGA352, 35 X 35 MM, BGA-352Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
RENESAS
UPD98433
Controller Miscellaneous - Datasheet ReferenceWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
ETC
UPD98433S9-K6
LAN Controller, 8 Channel(s), 125MBps, CMOS, PBGA756, 45 X 45 MM, PLASTIC, BGA-756Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
NEC
UPD98452
Analog ICWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
ETC
UPD98501
LAN Controller, 12.5MBps, CMOS, PBGA352, TBGA-352Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
NEC
UPD98501N7-F6
LAN Controller, 3 Channel(s), 12.5MBps, CMOS, PBGA352, 35 X 35 MM, BGA-352Warning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 211
-
NEC
©2020 ICPDF网 联系我们和版权申明