IS9-1845ASRH-QS9000 [RENESAS]
SWITCHING CONTROLLER;型号: | IS9-1845ASRH-QS9000 |
厂家: | RENESAS TECHNOLOGY CORP |
描述: | SWITCHING CONTROLLER 开关 |
文件: | 总3页 (文件大小:145K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Single Event Radiation Hardened High Speed, Current
Mode PWM
IS-1845ASRH, IS-1845ASEH
Features
• Electrically Screened to DSCC SMD # 5962-01509
The IS-1845ASRH, IS-1845ASEH are
designed to be used in switching
power supplies operating in current-
mode. The rising edge of the on-chip
• QML Qualified per MIL-PRF-38535 Requirements
TM
• Radiation Environment
- High Dose Rate. . . . . . . . . . . . . . . . . . . . .300 krad(SI) (Max)
- Low Dose Rate . . . . . . . . . . . . . . . . . . . . . .50 krad(SI) (Max)
- SEL Immune . . . . . . . . . . . . . . . . . . . . Dielectrically Isolated
oscillator turns on the output. Turn-off
is controlled by the current sense comparator and occurs when
the sensed current reaches a peak controlled by the error
amplifier.
2
- SEU Immune. . . . . . . . . . . . . . . . . . . . . . . . 35MeV/mg/cm
2
-6
2
Constructed with Intersil’s Rad Hard Silicon Gate (RSG)
dielectrically isolated BiCMOS process, these devices are
immune to single event latch-up and have been specifically
designed to provide a high level of immunity to single event
transients. All specified parameters are guaranteed and tested
for 300krad(Si) total dose performance at a high dose rate and
50krad(Si) total dose at a low dose rate.
- SEU Cross-Section at 89MeV/mg/cm . . . . . . 5 x 10 cm
• Low Start-up Current . . . . . . . . . . . . . . . . . . . . . . . 100µA (Typ)
• Fast Propagation Delay . . . . . . . . . . . . . . . . . . . . . . . 80ns (Typ)
• Supply Voltage Range . . . . . . . . . . . . . . . . . . . . . . . 12V to 20V
• High Output Drive. . . . . . . . . . . . . . . . . . . . . . . . 1A (Peak, Typ)
• Undervoltage Lockout . . . . . 8.8V Start (Typ), 8.2V Stop (Typ)
Detailed Electrical Specifications for these devices are
contained in the SMD 5962-01509. A “hot-link” is also
provided on our website for downloading the SMD.
Applications
• Current-Mode Switching Power Supplies
• Control of High Current FET Drivers
• Motor Speed and Direction Control
Pin Configurations
IS7-1845ASRH, IS7-1845ASEH
(8 LD CDIP2-T8 SBDIP)
TOP VIEW
IS9-1845ASRH, IS9-1845ASEH
(18 LD FLATPACK)
TOP VIEW
NC
COMP
VFB
1
2
3
4
5
6
7
8
9
NC
18
17
COMP
VFB
1
2
3
4
8
7
6
5
VREF
VCC
OUT
GND
VREF
VCC
VC
16
15
14
13
12
11
10
ISENSE
RTCT
NC
NC
OUT
NC
NC
ISENSE
RTCT
NC
GND
OSCGND
NC
NOTES:
1. Grounding the COMP pin does not inhibit the output. The output may be inhibited by applying >1.2V to the ISENSE pin.
2. This part should be operated with C = 3.3nF and R = 10k timing components only.
t
t
July 13, 2012
FN9001.5
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas Inc. 2003, 2008, 2012. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1
IS-1845ASRH, IS-1845ASEH
Ordering Information
INTERNAL
MKT. NUMBER
TEMP. RANGE
(°C)
PKG.
DWG. #
ORDERING NUMBER
PACKAGE
5962F0150901V9A
5962F0150902V9A
IS0-1845ASRH/Sample
5962F0150901VPC
5962F0150902VPC
5962F0150901VPC
5962F0150901QPC
5962F0150901QPC
5962F0150901VXC
5962F0150902VXC
5962F0150901VXC
5962F0150901QXC
IS7-1845ASRH/Proto
IS9-1845ASRH/Proto
IS0-1845ASRH-Q
IS0-1845ASEH-Q
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
-50 to +125
IS0-1845ASRH/Sample
IS7-1845ASRH-Q
8 Ld SBDIP
D8.3
IS7-1845ASEH-Q
8 Ld SBDIP
D8.3
IS7-1845ASRH-QS9000
IS7-1845ASRH-8
8 Ld SBDIP
D8.3
8 Ld SBDIP
D8.3
IS7-1845ASRH-8S9000
IS9-1845ASRH-Q
8 Ld SBDIP
D8.3
18 Ld Flatpack
18 Ld Flatpack
18 Ld Flatpack
18 Ld Flatpack
8 Ld SBDIP
K18.B
K18.B
K18.B
K18.B
D8.3
IS9-1845ASEH-Q
IS9-1845ASRH-QS9000
IS9-1845ASRH-8
IS7-1845ASRH/Proto
IS9-1845ASRH/Proto
18 Ld Flatpack
K18.3
Typical Performance Curves
10k
100
80
60
40
20
D
MAX
C470pF
C1000pF
1k
C2200pF
C4700pF
100
10
1
0
0.1
1
10
100
1
10
100
R TIMING RESISTANCE (kΩ)
R TIMING RESISTANCE (kΩ)
t
t
FIGURE 1. OSCILLATOR FREQUENCY vs R and C
t
FIGURE 2. MAXIMUM DUTY CYCLE vs R
t
t
FN9001.5
July 13, 2012
2
IS-1845ASRH, IS-1845ASEH
Substrate
Die Characteristics
DIE DIMENSIONS
Radiation Hardened Silicon Gate,
Dielectric Isolation
3090µm x 4080µm (121.6 mils x 159.0 mils)
Thickness: 483µm ± 25.4µm (19 mils ± 1 mil)
Backside Finish
Silicon
INTERFACE MATERIALS
Glassivation
ASSEMBLY RELATED INFORMATION
Substrate Potential
Type: Phosphorus Silicon Glass (PSG)
Thickness: 8.0kA ± 1.0kA
Unbiased (DI)
Top Metallization
ADDITIONAL INFORMATION
Worst Case Current Density
Type: AlSiCu
Thickness: 16.0kA ± 2kA
5
2
<2.0 x 10 A/cm
Transistor Count
582
Metallization Mask Layout
IS-1845ASRH
ISENSE
VFB
COMP
RTCT
OSCGND
VREF
GND
GND
OUT
VC
VCC
NOTES:
3. Both the GND pads must be bonded to ground.
4. The OUT double-sized bond pad must be double bonded for current sharing purposes.
5. The OSCGND double-sized bond pad must be double bonded to ground for current sharing purposes.
For additional products, see www.intersil.com/product_tree
Intersil products are manufactured, assembled and tested utilizing ISO9000 quality systems as noted
in the quality certifications found at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time
without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be
accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third
parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN9001.5
July 13, 2012
3
相关型号:
IS9-1845ASRH/PROTO
1A SWITCHING CONTROLLER, 500kHz SWITCHING FREQ-MAX, CDFP18, CERAMIC, DFP-18
RENESAS
©2020 ICPDF网 联系我们和版权申明